vtech 198858 2-in-1 Push & Discover Turtle User Guide
- June 6, 2024
- vtech
Table of Contents
- vtech 198858 2-in-1 Push & Discover Turtle
- INTRODUCTION
- INCLUDED IN THE PACKAGE
- GETTING STARTED
- IMPORTANT: BATTERY INFORMATION
- ASSEMBLY INSTRUCTIONS
- PRODUCT FEATURES
- ACTIVITIES
- CARE & MAINTENANCE
- TROUBLESHOOTING
- CONSUMER SERVICES
- PRODUCT WARRANTY/CONSUMER GUARANTEES
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
vtech 198858 2-in-1 Push & Discover Turtle
INTRODUCTION
Meet the 2-in-1 Push & Discover Turtle by VTech® ! This adorable little turtle and butterfly really are baby’s best friends! The easy-to grab handle is perfect for little hands and easily detaches for two ways of play. The light up Number button, Music button and Turtle & Butterfly button introduce the turtle and butterfly, counting, sounds, melodies and phrases.
INCLUDED IN THE PACKAGE
- 2-in-1 Push & Discover Turtle
- Handle
- Handle base
- Parent’s Guide
WARNING: All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging screws are not part of
this toy and should be discarded for your child’s safety.
NOTE: Please keep this Parent’s Guide as it contains important
information.
Removing the Packaging Locks:
- Rotate the packaging lock 90 degrees anticlockwise.
- Pull out the packaging lock and discard.
GETTING STARTED
Battery Removal and Installation
- Make sure the unit is turned Off.
- Find the battery cover located on the bottom of the turtle. Use a screwdriver to loosen the screw and then open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 2 new AAA batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni- MH rechargeable batteries are recommended.)
- Replace the battery cover and tighten the screw to secure.
WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
- Insert batteries with the correct polarity (+ and -).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not short-circuit the supply terminals.
- Remove batteries during long periods of non-use.
- Remove exhausted batteries from the toy.
- Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
- Remove rechargeable batteries from the toy before charging.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not charge non-rechargeable batteries.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and batteries, or on their
respective packaging, indicates they must not be disposed of in domestic waste
as they contain substances that can be damaging to the environment and human
health.
The chemical symbols Hg, Cd or Pb, where marked, indicate that the battery
contains more than the specified value of mercury (Hg), cadmium (Cd) or lead
(Pb) set out in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the market after 13th
August, 2005.
Help protect the environment by disposing of your product or batteries
responsibly.
VTech® cares for the planet.
Care for the environment and give your toy a second life by disposing of it
at a small electricals collection point so all its materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of
collection points near you.
In Australia & New Zealand: Check with you local council for kerbside
collections.
ASSEMBLY INSTRUCTIONS
With the 2-in-1 Push & Discover Turtle, safety comes first. To ensure your child’s safety, adult assembly is required.
-
Connect the Handle Top to the Handle Base as shown below.
Please note that once the handle pieces are connected, they cannot be separated. -
Attach the Handle Base to the turtle’s body by inserting the Handle into the slot on the back of the turtle.
-
To remove the Handle, press the two buttons on either side of the Handle Base and pull out the handle from the back of the turtle.
PRODUCT FEATURES
-
On/Off/Volume Switch
To turn the unit On, slide the On/Off/ Volume Switch to the Low volume position or the High volume position. You will hear a song and a welcoming phrase. To turn the unit Off, slide the On/Off/Volume Switch to the Off position. -
Automatic Shut-Off
To preserve battery life, the 2-in-1 Push & Discover Turtle will automatically shut off after approximately one minute without input. The unit can be turned on again by pressing any button or turning the back wheel.
NOTE: If the unit repeatedly powers down while playing, please install a new set of batteries.
ACTIVITIES
-
Number Button
Press the Number Button to learn about numbers and practise counting with playful phrases and fun sounds. The lights will flash with the sounds. -
Music Button
Press the Music Button to hear playful melodies and songs. The lights will flash with the sounds. -
Animal Button
Press the Animal Button to learn about the turtle and butterfly. The lights will flash with the sounds. -
Wheel Sensor
Push or pull the turtle with or without the handle attached to hear a variety of fun sounds and short tunes. Watch the turtle’s head bob and the butterfly’s wings flap up and down. The light will flash with the sounds.
MELODY LIST
- A-Tisket, A-Tasket
- Alphabet Song
- Bingo
- Ride a Cock Horse to Banbury Cross
- Glow Worm
- Hey, Diddle, Diddle
- Skip to My Lou
- Old MacDonald
- Pease Porridge Hot
- Row, Row, Row Your Boat
SONG LIST
Song 1
Let’s go for a stroll in the sun.
Stretch your legs and have some fun!
Little butterfly stretches her wings, too.
We’re ready for a great day exploring with you!
Song 2
One, two, three, four, walk with me,
I want to explore the world with you.
One, two, three, four, walk with me,
We can have fun, you and me!
CARE & MAINTENANCE
- Keep the unit clean by wiping it with a slightly damp cloth.
- Keep the unit out of direct sunlight and away from any direct heat sources.
- Remove the batteries if the unit will not be in use for an extended period of time.
- Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow these steps:
- Please turn the unit Off.
- Interrupt the power supply by removing the batteries.
- Let the unit stand for a few minutes, then replace the batteries.
- Turn the unit On. The unit should now be ready to play again.
- If the unit still does not work, install a new set of batteries.
CONSUMER SERVICES
Creating and developing VTech® products is accompanied by a responsibility that we at VTech® take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to call our Consumer Services Department with any problems and/or suggestions that you might have. A service representative will be happy to help you.
UK Customers:
Phone: 0330 678 0149 (from UK) or +44 330 678 0149 (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: 1800 862 155
Website: support.vtech.com.au
NZ Customers:
Phone: 0800 400 785
Website: support.vtech.com.au
PRODUCT WARRANTY/CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at
vtech.co.uk/warranty
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer guarantees apply to
goods and services supplied by VTech Electronics (Australia) Pty Limited.
Please refer to
vtech.com.au/consumerguarantees for
further information.
Visit our website for more information about our products, downloads,
resources and more.
www.vtech.co.uk
www.vtech.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>