AIMS POWER SCC10AFM Solar Charge Controller User Manual
- June 6, 2024
- AIMS Power
Table of Contents
- AIMS POWER SCC10AFM Solar Charge Controller User Manual
- Icons Chart
- Product Features
- Device Layout
- Mounting Instructions
- Wire Connection Sequences
- LCD Display Interface Overview
- Status Information
- Key Functionality Chart
- LCD Display
- Error Code Chart
- Controller Specification
- Product Dimensions
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
AIMS POWER SCC10AFM Solar Charge Controller User Manual
Icons Chart
Product Features
The AIMS Power 10 amp flush mount solar charge controller has a flush mount or flat design for flexible mounting options. The controller is compatible with 12V & 24V battery systems. This device will regulate the voltage coming from a solar panel (s), and safely charge the battery (s). Most commonly used in small solar systems.
FEATURES
- Charging modes available for most common deep-cycle battery types. AGM (sealed lead acid batteries), GEL, Flooded, and Lithium. User may also use the customized parameter mode.
- Automatically recognizes 12V or 24V battery banks
- 5V 1A USB outlet provides charging for mobile devices.
- Industrial grade design with reverse polarity protection for solar panels and battery
- Flat mount with bracket or flush mount fixture included.
Device Layout
Mounting Instructions
The SCC10AFM controller can be mounted flush or flat with included bracket. Mount in a dry and cool location. Do NOT allow controller to get wet.
Wire Connection Sequences
During installation, follow the sequence below:
- Connect the positive battery wire followed by the negative battery wire.
- Make sure your solar panel (s) is fully covered to prevent electric shock. Connect the positive solar array output wire followed by the negative solar array output wire.
- Connect the DC load wiring to the DC load output (if applicable).
LCD Display Interface Overview
Status Information
Key Functionality Chart
LCD Display
Start-up display will cycle when the controller turns on. It may cycle for several seconds while controller detects operating environment.
LCD Screen Display Cycle
• The screens will automatically cycle every 5 seconds. The user can also use the up and down keys to move through the screens.
• The error code page will display when an error is detected.
Setting Battery Mode
Advance Battery Settings
- In Lithium mode, press and release arrow key quickly and again to cycle through each parameter view.
- Use the load key to adjust parameter value, press and hold arrow key to save and exit.
Load Mode Settings
- Enter Load SET Mode by pressing the arrow key in Load Mode view only.
- Press and release the arrow key to cycle through load modes before pressing and holding the arrow key down again to save and exit.
Error Code Chart
- Contact AIMS Power for detailed troubleshooting.
AIMS Power
techsupport@aimscorp.net
775-359-6703
Controller Specification
- The variable “n” is adopted as a multiplying factor when calculating parameter voltages, the rule for “n” is listed as: if battery system voltage is 12V, n=1; 24V, n=2.
- For example, the equalize charge voltage for a 12V FLD (Flooded) battery bank is 14.8V*1=14.8V.
- The equalizing charge voltage for a 24V FLD (Flooded) battery bank is 14.8V*2=29.6V.
Product Dimensions
* Specifications may change without notice
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>