Eachine Nano V3 VTX User Manual

Eachine Nano V3 VTX

Product Parameters

• Built-in Microphone

• Input voltage: DC 5V

• PIT@75mA

• 25mW@180mA/ 1 6dBm

• 1 00mW@280mA/21 .5dBm

• 200mW@330mA/24.5dBm

• 400mW@400mA/27.5dBm

• Antenna interface: ipex

• Output power: PIT /25/1 00/200/ 400mW

• Standard 40 channels. A/B/E/F/R frequency group

• Installing Hole:
  • 20X20mm.M3
  • 25.5X25.5mm.M2

• Size: 28mm x 1 3.6mm x 5mm

• Weight: 3g

Wiring Diagram

Interface Definition

Function button settings

1. Setting methods for VTX parameters: OSD control through flight controller or VTX button control ;
2. The protocol used for OSD: IRC tramp.
3. The parameter table value for output power “25/1 00/200/ 400MW” is “25/100/200/400”;
   

Power indicator status

indicator light: red| Always light| 1 Flash stop| 2 Flash stop| 3 Flash stop| 4 Flash stop
---|---|---|---|---|---
Power indicator| PIT| 25mw| 100mw| 200mw|

400mw

Frequency sheet

Band
(Blue light)

|

CH(Green light)

---|---

1

| 2| 3| 4| 5| 6| 7| 8

A

| 5865| 5845| 5825| 5805| 5785| 5765| 5745|

5725

B| 5733| 5752| 5771| 5790| 5809| 5825| 5847|

5866

E

| 5705| 5685| 5665| 5665| 5885| 5905| 5905| 5905
F| 5740| 5760| 5780| 5800| 5820| 5840| 5860|

5880

R

| 5658| 5695| 5732| 5769| 5806| 5843| 5880|

5917

Button control definitions

1. Long press for 2 seconds, the LED indicator will start switching from channel, band and power repeatly (red for power, blue for channel, green for band)
2. Long press for 2 seconds until the blue indicator is ON for channel setup. Short press to switch channel. When CH1 is selected, the indicator flashes once; when CH2 is selected, the indicator flashes twice, and so on.
3. Long press for 2 seconds until the green indicator is ON for band setup. Short press to switch band (A->B->E->F->R->A repeatly). When Band A is selected, the indicator flashes once; when Band B is selected, the indicator flashes twice, and so on .
4. Long press for 2 seconds until the red indicator is ON for power setup . Short press to switch power (25mw->100mw->200mw->400mw->PIT , 25mw repeatly ). When 25mw is selected, the indicator flashes once; when 1 00mw is selected, the indicator flashes twice, and so on. The red indicator will be solid at Pit mode.
5. When the drone arms, long-press in advance to directly enter PIT mode.

Company: Lotus NL B.V
Address: Koningln Julia~plein 10, le Verd, 2595M, The Hague, Netherlands.
E-mail: peter@lotusnl.com
Tel: +31644168999

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>