TELTONIKA RUTX09 – LTE-A CAT6 Dual-SIM Router User Guide

TELTONIKA RUTX09 – LTE-A CAT6 Dual-SIM Router User Guide

OVERVIEW

FRONT VIEW

BACK VIEW

POWER SOCKET PINOUT

HARDWARE INSTALLATION

1. Pull out the SIM needle from the front panel of the router.
2. Push the SIM holder button with the SIM needle.
3. Pull out the SIM holder.
4. Insert your SIM card into the SIM holder.
5. Slide the SIM holder back into the router.
6. Attach all antennas.
7. Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.
8. Connect to the device via an Ethernet cable connected to LAN port.

LOGIN TO DEVICE

1. To enter the router’s Web interface (WebUI), type http://192.168.1.1 into the URL field of your Internet browser.
2. Use login information shown in image A when prompted for authentication.
3. After you log in, you will be prompted to change your password for security reasons. The new password must contain at least 8 characters, including at least one uppercase letter, one lowercase letter, and one digit. This step is mandatory, and you will not be able to interact with the router’s WebUI before you change the password.
4. When you change the router’s password, the Configuration Wizard will start. The Configuration Wizard is a tool used to set up some of the router’s main operating parameters.
5. Go to the Overview page and pay attention to the Signal Strength indication (image B). To maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.

TECHNICAL INFORMATION

Radio specifications

RF technologies| 3G, 4G, GNSS
Max RF power| 24 dBm@WCDMA, 23 dBm@LTE
Bundled accessories specifications
Power adapter| Input: 0.6A@100-240VAC, Output: 12VDC, 1.5A, 4-pin plug
Mobile antenna| 698-960/1710-2690 MHz, 500, VSWR<3, gain 3 dBi, omnidirectional, SMA male connector
GNSS antenna| 1575.42-1602 MHz, 22-5 VDC, VSWR<1.5, active total gain 28 dB (typ.), RHCP polarization, SMA male connector

Order code dependent.
Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.

SAFETY INFORMATION

RUTX09 router must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.

Hereby, TELTONIKA declares that this RUTX09 is in compliance with the essential requirements and other relevant provisions of Directive CE/RED.

] Instruction Manual: Connect the power adapter to turn on the device. Open 192.168.1.1 in your web browser to configure it. More information on
https://wiki.teltonika-networks.com/

The full text of the EU declaration of conformity is available at the following
internet address: https://wiki.teltonika-networks.com/view/RUTX09_CE/RED

This sign means that all used electronic and electric equipment should not be mixed with general household waste.

This sign means that product meets the requirements of the applicable EU directives.

References

• Teltonika Networks - LTE Routers, Gateways & Modems for IoT
• wiki.teltonika-networks.com/
• RUTX09 CE/RED - Teltonika Networks Wiki

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>