NUSICAN N18 Car Battery Jump Starter User Manual

**NUSICAN N18 Car Battery Jump Starter User Manual

**

Apart from jump starting a car, this product can also supply power for a mobile phone. laptop, PSP, MP3/MP4, camera and other consumer electronics, and with different lighting modes.

• Jump start a car

• Change cell phone/Tablet

• Change PSP
  

• Outdoor travel flashlight

• Video Charge camera/Video
  

AT A GLANCE

1. Power Button

2. Power indicator light
   

3. Smart Jump Clamps Port

4. Output 2(5V/2.1A)

5. Output 1(5V/3A, 9V/2A, 12V/1.5A)

6. LED light / Torch light /SOS

7. Power Input / Output (5V/3A)

8. DC Output Port (12-16V)
   

HOWTO CHARGE CELLPHONES OR OTHER DIGITAL PRODUCTS

1. Plug the USB Port of the charging cable into the product USB interface

2. Inset the other side into the input port of the mobile phone

3. When connected OK, press then you can use it to charge now
   Power

HOW TO USE THE LED EMERGENCY LIGHT

• Power
• Hold for 3 seconds to turn light on,
• then press 0 lightly, led light will shift to flashing.
• SOS then press  for 3 seconds, the led light will be off

HOW TO RECHARGE THE DEVICE

Plug the charging cable Type-C In (Out)

Inset the other side into the 2210W(110V) power. the indication light will be flicking, which shows it is under charging.

Parameter

PACKAGE CONTENT

• 1 x intelligent Jumper Clamps

• 1 x Jump Starter

• 1 x User Manual

• 1x USB Type-C Cable

HOW TO JUMP START YOUR CAR

1. Plug the jumper cable into the battery pack
   

2. Connect the jumper clamps to the car battery (Red is positive and Black is negative)
   

3. Start the car by turning on the ignition key

4. After the car has been started, remove the plug from the battery pack and remove the clamps from the car battery
   

Note: Ensure the jump starter power level is 50% or more before jumping your car. Connect the positive(+ )(red) clamp from the jump starter to the positive terminal of the car battery, and connect the negative (-)(black) clamp to the negative terminalof the car battery.

ADVICE WARNINGS INDICATED ON THE DISPLAY

• LOW VOLTAGE
  The characters ‘LV’ appear on the screen and the warning plays once per second. The screen will show a voltage lower than 14V.
  

• HIGH VOLTAGE
  The characters 1388″ appear on the screen and the warning tone plays.
  

• REVERSE CHARGE
  The characters RC appear on the screen. The symbol’s-2 flashes and the warning tone plays once per second. Standby mode will resume immediately once the error is corrected.
  

• REVERSE POLARITY OR SHORT CIRCUIT
  The character ‘RESC appears on the screen. The’–= symbol flashes and the warning tone plays once per second. Standby mode will resume immediately once the error is corrected.
  

• HIGH TEMPERATURE
  The characters ‘Fir appear on the screen. The symbol Rashes and the warning tone plays once per second. Normal operation will resume once the device temperature lowers.
  

• EXCESS CONNECTION TIME
  When connection time is too long for the clamps. the “—’ symbol will flash on the screen, try step 2&3 of jump start again.
  

FCC Warning

This Device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: Dangers, Warnings and Cautions In Handing The Battery

1. Please charge 3 hours or more before the first use. If the battery is stored for more than 3 months, the product needs to be charged once to ensure the normal performance of the product.
2. Please make sure the battery power of the jump starter is above 50% before use.
3. Do not use it continuously for more than 3 seconds. There should be at least 30 seconds between starting twice.
4. Never short-circuit the jump starter by connecting Red and Black clips. (In case of revers polarity connection by mistake, the product comes with related protection measurements to avoid lif-injury & properly loss).
5. After the car start, please unplug the plug from the product first, and then remove the clip on the battery.
6. Do not disassemble the jump starter.
7. When children use the product, please operate under the guidance of parents.
8. Store in a dry place, do not expose to wet conditions or nearby corrosive materials.
9. If the jump starter swells and a leak or peculiar smell is found, stop using immediately.

ACTIVATE YOUR 12-MONTH WARRANTY
& GET YOUR EXLUSIVE GIFT
Register within 7 days after receiving your new product.

PLEASE VISIT:
www.nusican.net/warranty
CUSTOMER SERVICES
us-jumper@nusican.net

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>