HOOVER CH50200 Lightweight Commercial Vacuum Cleaner User Guide
- June 12, 2024
- Hoover
Table of Contents
HOOVER CH50200 Lightweight Commercial Vacuum Cleaner User Guide
WARNING : Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance- if it will not fit the outlet, have a proper outlet installed by a qualified electrician. When using an electrical appliance, basic precautions should always be followed to reduce risk of fire, electric shock or injury.
WARNING : Reduce risk the risk of personal injury due to a loose electrical connection between the appliance’s plug and extension cord, firmly and fully attach the appliance plug to the extension cord. Periodically check the connection while operating to ensure it is fully attached. Do not use an extension cord that provides a loose connection. A loose connection may result in overheating, fire, and increases the risk of burning.
ASSEMBLY
1. Before assembling appliance, remove two screws from the connector assembly. Remove plastic insert by pulling upward.
2. With ON/OFF switch facing the front, slide upper handle section over matching section of the connector assembly. Hold handle brace against upper handle and align screw holes. Insert one screw into top hole and one screw into the bottom hole, then tighten firmly until handle is no longer loose.
3. Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip.
REPLACING THE BAG
All paper dust bags are NOT the same. Your Hoover® Commercial disposable dust bags have been designed to be used with the Hoover® Commercial cleaner. Using bags other than genuine Hoover® Commercial disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.
Available replacement bag model numbers that work with this vacuum
MODEL NO. AH10200
1. Unzip outer bag and remove filled bag. Hook bottom of bag collar opening under lip “B” of connector assembly. Pull up on bag collar and snap over lip “A” of connector.
2. Press on edges of bag collar to insure bag is completely installed.
IMPORTANT: Make sure bag collar is behind lips “A” and “B”. If it is not, dust will leak into outer bag. When filter bag is in place, close outer bag with zipper fastener.
CORD LOCK INSTALLATION
1. Route the plug coming from the unit through the rectangular hole in the cord lock.
2. Connect plug coming from the unit to the receptacle of the extension cord.
3. Route the extension cord through the hook on the cord lock.
4. Remove excess slack until both the plug and receptacle are lying on the cord lock.
For all safety precautions, please see User Manual.
Hoover.com
HooverCommercial.com
©2022 Techtronic Floorcare Technology Limited
Dial: 1-888-768-2014 (M-F EST 8AM – 4
PM CST) to speak with a Customer Representative.
964A00290-R0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>