TrickleStar 7-Outlet AV Advanced PowerStrip TS1810 User Guide
- June 6, 2024
- TrickleStar
Table of Contents
TrickleStar 7-Outlet AV Advanced Power Strip TS1810 User Guide
Product Overview
-
IR & Motion Multi-Sensor
The multi-sensor connects to the powerstrip via the RJ11 port marked “sensor.” -
Power Connection
The Advanced PowerStrip+ (APS+) must be plugged into a grounded outlet to be properly surge protected. Use of an extension cord, adaptor or other powerstrip in conjunction with the APS+ will void all warranties. -
Sensor/RJ11 Port
Plug the multi-sensor into this port. There will be a soft, audible “click” when the connector is inserted correctly. -
Surge LED
When illuminated, it indicates that the surge protection is functioning normally. If this LED does not illuminate, it indicates that the surge protection function has been damaged while protecting your devices, and the product must be replaced. -
Ground LED
When illuminated, it indicates that the APS+ is correctly grounded. If not illuminated, there is a grounding problem and you must contact an electrician to properly ground the socket. Surge protection will not work with an improperly-grounded outlet. -
Switched LED
When illuminated, it indicates that the switched outlets have power and devices plugged into them can be used. -
Resettable Circuit Breaker
If the surge, ground, and switched LEDs are not illuminated and/or electronics plugged into the APS+ won’t turn on, press the circuit breaker to manually activate power. -
Always-on Outlets
Electronics that require continuous power should be plugged into the always-on outlets. -
< tv > Outlet
The outlet marked < tv > is the control outlet. IMPORTANT: THE TV MUST BE PLUGGED INTO THIS OUTLET -
Switched Outlets
If the TV is turned off or there is no IR remote activity or motion detected, the devices plugged into these outlets will automatically turn off. -
TAV-Link Cable (sold separately)
TAV-Link sends high-level CEC commands to certain HDMI connected devices, allowing them to safely store their data and settings prior to powering down.
Setup Guide
–
1 TAV-Link functionality will softly switch off (place into an energy-saving
mode) HDMI-connected peripherals capable of receiving Consumer Electronic
Control (CEC) commands if no IR remote control activity or motion is detected.
2 Game consoles without hard disk drives (HDDs) should be plugged into a
switched outlet. Game consoles with hard disk drives should be plugged into an
always-on outlet.
AV Advanced Powerstrip+
Setup Instructions
Before First Use
This APS+ features auto-threshold sensing technology. This learns the normal power draw of your TV, known as a power profile. After setup, you need to teach the APS+ the power profile of your TV.
Operation Modes
TV Mode
Music Mode
Press any button except the power button on an Infrared (IR) remote for any of the electronics plugged into the power strip to turn on the switched outlets.
Press power on all music related devices to turn them on.
Note:
- If the TV is not turned on while in music mode, all switched outlets will turn off after eight hours.
- If the TV is turned on during music mode, the APS+ will switch to TV mode.
Changing the Countdown Timer
To adjust the countdown timer, press and hold the button for 10 seconds until the red LED illuminates. Then press:
- Once for 30 minutes (IR + motion sensing)
- Twice for 60 minutes (IR + motion sensing)
- Three times for 120 minutes (IR + motion sensing, default setting)
- Four times for 60 minutes (IR-sensing only)
- Five times for 120 minutes (IR-sensing only)
After countdown timer is set, the LED will flash the number of times the button was pressed to indicate the setting.
Disabling the Buzzer
The sensor has a default buzzer that will sound 10 minutes and 3 minutes prior to shutdown. To disable the buzzer, press and hold the button for 10 seconds until the red LED illuminates, then press the button six times. The red LED will flash six times to confirm that the buzzer has been disabled.
Sensing Modes
IR + Motion Sensing
Countdown Timer Operation for Multi-Sensing
- For the first 15/30/60 minutes – the multi-sensor looks for IR remote activity only.
- For the next 15/30/60 minutes – the multi-sensor looks for IR remote activity and motion.
- If no IR remote activity or motion has been detected during the 30/60/120 minute countdown period, the switched outlets and the items plugged into them turn off, including the TV.
IR-Only Sensing
Countdown Timer Operation for IR-only Sensing
- For 60/120 minutes – the multi-sensor looks for IR remote activity.
- If no IR remote activity is detected during the 60/120 minute countdown period, the switched outlets and the items plugged into them turn off, including the TV.
FAQ
What can I plug into the APS+?
The APS+ is intended to be used with a television and related electronics.
- Never insert any object other than a plug into the APS+ outlets.
- The APS+ is designed for indoor use only. Do not use it outside.
- Never use the APS+ with appliances, such as refrigerators, electric kettles, oven, microwaves, etc.
- Never use the APS+ with power tools such as power drills, bench saws or similar.
What TV-related electronics should I plug into the grey always-on
outlets?
Plug in Audio Visual (AV) electronics that need constant power for recording
features, timers and program guides, such as:
- Digital Video Recorders (DVRs)
- Digital receivers
- Set-top boxes
- Game consoles with HDDs
What TV-related electronics should I plug into the switched outlets?
The TV must be plugged into the green outlet labelled < tv >. Plug in devices
such as the following in to the remaining switched outlets:
- Blu-ray player
- Amplifier
- Game consoles without HDDs
- Home theatre speakers
- DVD Player
- CD Player
- Soundbar
How does the APS+ save energy?
The APS+ saves energy two ways:
- Eliminates standby power
- After the TV is turned off, the switched outlets turn off within one minute and no longer draw any power.
- Monitors activity and powers down unused electronics
- In TV Mode, all switched outlets turn off if there is no IR remote activity or motion detected during the countdown period.
- In Music Mode, all switched outlets turn off after eight hours.
- By using the optional TAV-Link cable, HDMI-connected peripherals capable of receiving CEC commands will automatically soft-switch off or enter a power saving mode if there is no IR remote activity or motion detected during the countdown period.
Troubleshooting
Product Warranty
The Product Warranty is 10 years (hereafter referred to as Product Warranty).
TrickleStar warrants to the original purchaser that for the Product Warranty,
it shall be free of defects in design, assembly, material, or workmanship, and
will repair or replace, at its option, any defective product free of charge.
CONNECTED DEVICE WARRANTY
TrickleStar will repair or replace, at its option, any devices which are
damaged by a transient voltage surge/spike or lightning strike, (an
“Occurrence”), while properly connected through the Product to a properly
wired AC power line with protective grounding.
If applicable; the telephone line, and/or network line must be properly connected and installed, and the antenna cable line must also be properly connected and installed, as determined by TrickleStar at its sole discretion.
This Connected Device Warranty is a Limited Warranty, subject to the limitations and exclusions set forth herein. TrickleStar will repair or replace the damaged connected devices, at Trickle Star’s option, an amount equal to the fair market value of the damaged devices or the original purchase price of the devices, whichever is less, up to the maximum of: $100,000
The fair market value of the devices shall be the current value of the devices
specified in the most recent edition of the Orion Blue Book online on
Usedprice.com.
TrickleStar reserves the right to review the damaged Product, the damaged
devices, and the site where the damage occurred.
All costs of shipping the Product and the damaged devices to TrickleStar for inspection shall be borne solely by the purchaser. TrickleStar reserves the right to negotiate the cost of repairs. If TrickleStar determines, in its sole discretion, that it is impractical to ship the damaged devices to TrickleStar, TrickleStar may designate, in its sole discretion, a repair facility to inspect and estimate the cost to repair such devices. The cost, if any, of shipping the devices to and from such repair facility and of such estimate shall be borne solely by the purchaser.
Damaged devices must remain available for inspection until the claim is finalized. Whenever claims are settled, TrickleStar reserves the right to be subrogated under any existing insurance policies the claimant may have. All above warranties are null and void if:
- The Product in use during the occurrence is not provided to TrickleStar for inspection upon TrickleStar’s request at the sole expense of the purchaser
- TrickleStar determines that the Product has not been installed in accordance with the Installation Requirements, altered in any way or tampered with
- TrickleStar determines that the damage did not result from the occurrence or that no occurrence in fact took place, the repair or replacement of the damaged devices is covered under a manufacturer’s warranty
- TrickleStar determines that the connected devices were not used under normal operating conditions or in accordance with any labels or instructions
- The Product is not plugged directly into a receptacle
- The Product is “daisy-chained” together in serial fashion with other power boards, UPS’, other surge protectors or extension cords
- A three-to two-prong adapter is used
- The Product is not used indoors
This Product is not for use with aquariums and all other water-related products. Use only indoors and in dry locations. The Connected Device Warranty only protects against damage to properly connected devices where TrickleStar has determined, in its sole discretion, that the damage resulted from an occurrence, and does not protect against acts of God (other than lightning) such as flood, earthquake, war, vandalism, theft, normal-use wear and tear, erosion, depletion, obsolescence, abuse, damage due to low voltage disturbances (i.e. brownouts or sags), non-authorized program, or system devices modification or alteration. This warranty contains the sole warranty of TrickleStar, there are no other warranties, expressed or, except as required by law, implied, including the implied warranty or condition of quality, merchantability or fitness for a particular purpose, and such implied warranties, if any, are limited in duration to the term of this warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
In no event shall TrickleStar be liable for incidental, special, direct, indirect, consequential or multiple damages such as, but not limited to, lost business or profits arising out of the sale or use of any Product, even if advised of the possibility of such damages. This warranty gives you specific legal rights, and you may also have other rights, which may vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damage, so the above limitations may not apply to you.
This warranty is valid only for the original purchaser of the product. All
damage claims against the product must be made within 30 days from the date of
the occurrence and must be accompanied by a receipt for the damaged devices or
the warranty is void.
Warranty is valid in the United States and Canada.
MAKING A WARRANTY CLAIM
Go to: www.tricklestar.com and print our claim
form and email it to
warranty@tricklestar.com
Provide the following information:
- Product part number
- A list of the devices that were connected to the Product at the time of the occurrence
- A list of the devices that were damaged during the occurrence and the extent of the damage
- The date of the occurrence
- Where you purchased the Product
- When you purchased the Product
- A copy of original receipt
A customer service representative will then instruct you on how to forward your devices, receipt and Product in use during the “occurrence” and how to proceed with your claim.
COPYRIGHT & DISCLAIMER
© 2020 TrickleStar Inc. All rights reserved. TrickleStar® is a registered
trademark of TrickleStar Ltd. Any typographical, clerical or other error or
omission in this document or other documents or information issued by
TrickleStar shall be subject to correction without any liability on the part
of TrickleStar without notice.
Need Help?
www.tricklestar.com/gethelp.html
About TrickleStar
TrickleStar was founded in 2007 with the belief that collectively, small actions by a large number of people can result in significant energy savings.
Based on this belief, we create products that reduce energy consumption in homes and businesses.
Today, we are the preferred choice of electric utilities, energy efficiency programs, implementation contractors and energy auditors.
Patents Pending & Patents
9,665,073 B2 7,193,335 B2
188LV-US-7XXXA-MA4BM
For technical support go to www.tricklestar.com
or call 1-888-700-1098
REV 12/10 Dec 2020
References
- Used Equipment Blue Book Values and Online Fair Market Value Price Guides for Guns, Computers, Audio Equipment, Musical Instruments and more by UsedPrice.com
- TrickleStar | Energy-Efficient Smart Devices - Home & Office
- Get Help – TrickleStar
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>