SONOFF SNZB-01 Mini Zigbee Wireless Switch User Guide
- June 6, 2024
- SonOFF
Table of Contents
SONOFF SNZB-01 Mini Zigbee Wireless Switch User Guide
The device can be operated intelligently via working with the SONOFF Zigbee bridge to communicate with other devices
The device can work with other gateways supporting ZigBee 3.0 wireless protocol. Detailed information is in accordance with the final product.
DOWNLOAD APP
Pull Of The Battery Insulation Sheet
Add Sub Devices
Connect the bridges before adding the sub device
WeLink App
Access eWeLink APP, select the Bridge that you want to connect, and tap “Add” to add a sub-device. Then long press “RST” reset button on the device for 5s until the LED indicator flashes three times, which means the device has entered the pairing mode, and be patient until pairing completes.
If the addition failed, move the sub-device closer to the Bridge and try again.
User manual
https://www.sonoff.tech/usermanuals
Scan the QR code or visit the website to learn about the detailed user manual and help.
FCC Warning
Changes or modifications not expressly approved by the party responsible for
compliance could avoid the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Hereby, Shenzhen Sonoff Technologies Co., Ltd. declares that the radio
equipment type SNZB-01 is in compliance with Directive 2014/53/EU.The full
text of the EU declaration of conformity is available at the following
internet address:
https://www.sonoff.tech/usermanuals
Like it
Glad to know you are satisfied with SONOFF products. It would mean a lot to us
if you can take a minute to share your buying experience.
Share it on amazon
Share it on your social media
Share it on your media
HAVE A PROBLEM?
We are so sorry for the inconvenience caused by the product. Please contact us for help via the email address below.
support@itead.cc
We will get back to you as soon as possible.
YouTube
Facebook
Website: sonoff.tech
ZIp code: 518000
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>