maono WM600 B2 Wireless Microphone System User Guide
- June 4, 2024
- maono
Table of Contents
WM600 B2 Wireless Microphone System
User Guide
WM600 B2 Wireless Microphone System
Key operation and LED lighting instructions
Buttons (Transmitter TX1 & TX2)
On/Off button – Press and hold for three seconds to switch the machine;
Short press to turn mute on and off;
Double-click to turn noise reduction on or off.
RESET – use a pin to press the reset button for 3 seconds.
Connector (Transmitter TX1 & TX2)
USB C charging port – DC 5V.
*LED indicator (Transmitter TX1 & TX2)
There is a light hole on the front, which is displayed by RGB monochrome
lights (red, green, blue);
After fully charged, the red indicator light will be off;
Greenlight: connection is always on, search flashes slowly, clear pairing
flashes quickly.
The side indicator is used to display the mute state, and the red light is on
when it is muted, and the light is off in normal use.
Buttons (Receiver RX)
RESET – use a pin to press the reset button for 3 seconds.
Connector (Receiver RX)*
Attach to an iOS device with a Lightning connector and provide audio output.
3.5mm headphone jack for real-time transmitter sound monitoring and playing
back the sound on the phone.
LED Indicator (Receiver RX)**
Connection indicator:
Normal connection is always on the green;
Disconnected from the transmitter, the green light flashes slowly;
The green light flashes quickly when the pairing is cleared;
When noise reduction is turned on, the blue light is always on. 
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: 1. This device may not cause harmful
interference, and 2. This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following.
Measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the.
- the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Technical support: support@maono.com
www.maono.com
Company: Qing UG (haftungsbeschrankt)
Address: Undinestr. 7,12203 Berlin Germany
Tell: 004917662179550
E-mail: pmdheinrich@gmail.com
Company: CET PRODUCT SERVICE LTD.
Address: Chase Business Centre, 39-41
Chase Side, London N14 5BP United Kingdom
Email: info.cetservice@gmail.com
TEL: +447419325266
Made in China
Final clause: Information and data contained in this manual are subject to
change without notice in advance.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>