MEGA DECO Flex L User Manual
- June 6, 2024
- MEGA
Table of Contents
USER MANUAL
Check that the unit has not been damaged during transport
Read all cautions and warnings prior to operation of this equipment
Protection Against Fire
- Maintain a minimum of 1-foot distance from any type of flame.
- Do Not install the unit too close to a heat source.
- Make sure cables are properly secured away from the movement.
- Maximum surface operating temperature is 125°F
- Unit must not be left on for long periods of time.
Protection Against Electrical Fire
- Disconnect power before servicing.
- For connection to main power supply proceed to page 5.
- This fixture must not be left on for long periods of time.
Protection Against Mechanical Hazards
- Use safety measures when hanging unit.
- Use quality clamps or bolts when positioning unit
- Do not open, risk of electrical shock.
Ingress Protection
The IP rating is commonly expressed as IP (Ingress Protection) is followed by 2 numbers (i.e. 66) where the numbers define the fixture rating. The first number indicates the size of a particle that can enter the fixture.. The second number indicates the extent of protection against water entering the fixture. An IP66 rating in this fixture indicates that dust particles can not enter the fixture. And there is protection against powerful water spray from entering the fixture from any direction.
What is Included
1pc Deco Flex L
6pc Single Point Mounting Clips
1pc User Manual
Specifications
Part Numbers
Fixture
5050L– Deco Flex L
Mechanical Specifications
| IP Rating: | IP66 |
|---|---|
| Fastening System: | 6 Mounting Clips (included) |
| Power Connection: | 5 Conductor Cable |
| Housing: | Silicone type material (3 type) |
| Housing Type: | Flat Top |
| Curving Type: | Up & Down Curve (when light output is facing up) |
| Length: | 19’ Feet 10.5” Inch Including Cable (605.79cm) |
| Cuttable: | Cuttable mark located on the bottom, Cuttable every 2.81” inch |
(71.42mm)
LED Spacing:| 46” inch (11.9mm)
Electrical Specifications
| LED Type: | SMD 5050 R,G,B,WW |
|---|---|
| LED Qty: | 504 |
| Color Temp WW: | 3000K |
| Each LED Watts: | .19 |
| Power Input: | 24V |
| Total Max Power: | 94W |
| Drive Method: | Constant Voltage |
Main Power Connection
Caution!
- Deco Lighting fixtures are specifically designed to be used with Deco Drivers.
- Connection points must not be exposed to moisture or liquids. Use IP Rated Connections rated for outdoor use.
- Maximum Cable distance of 100ft before voltage drop.
- Connect only 1 Deco Flex per Deco Driver output.
The occupation of the connection cable is as follows:
| COM | Voltage + | Black Cable |
|---|---|---|
| R | Red | Red Cable |
| G | Green | Green Cable |
| B | Blue | Blue Cable |
| W | Warm White | White Cable |
DMX-512 Control
When using the Deco Flex L with Deco Drivers the fixture is intended to be used in Ch4 or Ch7 modes. The Deco Driver will be required to be set in Ch4 or Ch7 operating modes
Ch4 Mode
Red
Green
Blue
Warm White
Ch7 Mode
Dimmer
Red
Green
Blue
Warm White
Strobe
Macro
Deco Driver Info
Deco Driver Info
| Power Link | 1 Unit | Can connect 1 unit per output port |
|---|---|---|
| Ch Mode | Ch 4 or Ch7 | Use Ch4 or Ch7 Mode to control the unit |
Size & Weight
| Fixture Size | 19’10.5″ (605.79cm) X 18mm X 18mm |
|---|---|
| Fixture Packaged | 15″ X 15″ X 1.5″ |
| Net Weight | 4lb |
| Gross Weight | 4.1lb |
Cleaning and Maintenance
Installation Maintenance : The operator has to make sure that the unit is operating safely and has the installation and electronics checked by an expert every 2 years.
The following points have to be considered during the inspection:
- All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
- There must not be any deformations on the housing, fixation, and installation spots.
- The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables), or sediments. Further instructions depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems have to be removed.
- Flex Tube must only be cleaned using soap and water
Rigging the Fixture
Caution!
- The installation must be carried out by an authorized dealer or trained professional.
- Unit may cause severe injures if you have doubts concerning the safety do not install.
- Unit is to be 24inches away from flammable materials (decoration material)
When rigging a unit it is very important that you follow common safety
procedures. Rigging requires extensive experience including but not limited to
calculating working loads, material being used, and periodic safety
inspections. If you lack these qualifications, do not attempt the installation
yourself, instead use a professional structural rigger.
When rigging the unit always be secured with a secondary safety attachment.
The installation location of the Fixture has got to be built in the way that
it can hold 10 times the weight for 1 hour without any failures. Installation
should be checked at least one time a year by a skilled person.
Accessories
Warranty Information
Warranty Conditions
-Unless otherwise stated in writing, your product is covered by a one-year parts and labor limited warranty.
-LEDs and LAMPS are not guaranteed to match in color or output.
-It is the owner’s responsibility to furnish receipts or invoices for verification of purchase, date, and reseller or distributor. If the purchase date cannot be provided, the date of manufacture will be used to determine the warranty period.
-Goods returned under warranty must follow the proper authorization procedure and must be accompanied by a copy of the original invoice.
-Goods repaired under warranty will be returned to the owner with the freight prepaid by MSI via the most economical means of shipment.
-Repair or replacement as provided for under this warranty is the exclusive remedy of the consumer. MEGA SYSTEMS INC. makes no warranties, express or implied, with respect to any product, and Mega Systems specifically disclaims any warranty of merchantability or fitness for a particular purpose. Mega Systems shall not be liable for any indirect, incidental, or consequential damage, including lost profit, sustained or incurred in connection with any product or caused by a product defect or the partial or total failure of any product regardless of the form of action, whether in contract, tort (including negligence), strict liability or otherwise, and whether or not such damage was foreseen or unforeseen.
– Warranty is void if the product is misused, damaged, modified in any way, or
for unauthorized repairs or parts. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
Customer Support
Mega Lite has a customer support line to provide set-up help and to answer any
question should you encounter a problem. Please visit our website for any
other related technical documents. For service-related issues please contact
our service dept.
Monday—Friday 9am to 6pm CST Voice:
210-684-2600 E-mail:
service@megasystemsinc.com
Manual Version
Please Visit www.mega.lighting for the most up to date manual version
Document
Version
| Date| Fixture Software| Notes
---|---|---|---
1.2| 12/09/2020| N/A| Power Input Updated
Mega Lite
18668 Highway 16N
Helotes, Texas 78023
Ph 210-684-2600 Fax
210-855-6279
www.mega.lighting /
info@mega.lighting
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>