RUGGED RIDGE JLU Cargo Storage Drawers Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE JLU Cargo Storage Drawers
Product Information
- Product Name: Cargo Storage Drawers, JLU
- Part Number: 13551.42
- Manufacturer: Omix-ADA
- Address: 460 HORIZON DR. SUITE 400, SUWANEE, GA 30024
- Phone: 770-614-6101
- Fax: 770-614-6069
- Email: info@omix-ada.com
Product Usage Instructions
- Fold the rear seats forward and remove the OE bin cover.
- Using a T40 socket, remove the OE tie-downs.
- Remove the carpeted side plates.
- Before installing the cabinet, the drawers need to be removed from the cabinet. Pull both release springs inboard to remove the drawers. Note that the drawers are side-specific.
- Insert the cabinet into the cargo area.
- Align the cross bars of the cabinet base with the OE tie-down threaded holes in the floor and insert the provided spacers.
- Insert the supplied bolts with lock washer and flat washer through the cross bars, spacer, and thread into the factory threaded holes. Do not tighten at this time.
- Fold the rear seats back up and check the alignment of the cabinet. Once aligned, tighten all hardware.
- Reinstall the drawers, ensuring that they are side-specific and the rollers are properly aligned with the tracks. Close the drawers. The release springs may need to be pulled inboard for ease of installation.
- To utilize the workstation, release the finger trigger as shown and slide the workstation out.
Components
- Cargo Storage Drawers………………….(1)
- Allen Head Bolt………………………………(4)
- Flat Washer…………………………………….(4)
- Lock Washer…………………………………..(4)
- Billet Spacer……………………………………(4)
- Allen Wrench………………………………….(1)
INSTALLATION INSTRUCTION
-
Fold rear seats forward then remove the OE bin cover.
-
Remove the OE tie-downs with a T40 socket.
-
Remove carpeted side plates.
-
The drawers need to be removed before putting the cabinet in the vehicle. Pull both release springs inboard to remove the drawers from the cabinet.
NOTE: Drawers are side specific. -
Insert cabinet into cargo area.
-
Align cross bars of cabinet base with OE tiedown threaded holes in floor and insert provided spacers.
-
Insert supplied bolts with lock washer and flat washer through cross bars, spacer and thread into factory threaded holes. DO NOT TIGHTEN AT THIS TIME.
-
Fold rear seats back up and check alignment of cabinet. Once aligned, tighten all hardware.
-
Reinstall drawers.
NOTE: Drawers are side specific. Ensure rollers are properly aligned with tracks and close drawers. Release springs MAY need to be pulled inboard for ease of installation. -
To utilize the station, release finger trigger as shown and slide the station out.
Copyright © 2021 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE:
770-614-6101 | FAX:
770-614-6069 | info@omix-
ada.com
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST
1-800-449-6649 | EMAIL:
techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>