MEGA LITE DRAMA WL 100 Low Profile Work Light Solution User Manual

MEGA LITE DRAMA WL 100 Low Profile Work Light Solution

Protection Against Fire

1. Maintain a minimum of 1 foot distance from any type of flame.
2. Replace fuse only with the specified type and rating.
3. Do Not install the unit to close to a heat source.
4. Make sure cable are properly secured.
5. Maximum surface operating temperature 80º.
6. Do not leave fixture on for long periods of time.

Protection Against  Electrial Fire

1. Disconnect power before servicing.
2. For connection to main power supply proceed.
3. This unit must be earthed electronically grounded.
4. Do not expose unit to rain or moisture.

Protection Against Mechanical Hazards

1. Use safety chain when hanging unit.
2. Use quality clamps or bolts when positioning unit.
3. Do not open unit while it is on, risk of electrical shock.

Mechanical Specifications

• Power Connection: Power Con type in & out
• Thermal: ambient temperature 100°f
• Maximum surface temperature 130°f
• Fastening System: Single Mounting Yoke
• LED Angle:40°
• Barn Doors: Included

Electrical Specifications

• LED Quantity:324 White SMD LEDS 6500K
• Power Input Voltage:110V-240 50/60 Hz
• F5AL250V
• Ballast: Electronic auto switching
• Power Consumption Watts: 100 Amps: .85
• LED Watts:3
• LED Lifetime: 60 to 100 thousand hours average
• LED Scan rate:  7000H
• Fuse : 5×20

Size and Weight

Size: 13.7 x 5 x 8

Weight: 6.5 lb

| Size: 30.5 x 23 x 20.66

Weight: 60.5 lb empty

Main Power Connection

Caution

1. Do not connect fixture to a dimmer system.
2. This unit has Auto switching power supply.
3. It will respond to 110V or 220V automatically
4. This unit must be earthed electronically grounded.
5. Replace fuse only with the specified type and rating.
6. Maximum power Link 15 at 110V ,31 at 220V
7. The occupation of the connection-cable is as follows
8. This fixture is equipped with an electronic power supply that will let the unit operate from 100V to 240V from 50Hz to 60Hz.

110V  Connection

 220 Connection

Control

Intensity Control

Intensity Control can be selected by rotating the knob to clockwise for the desired setting. There is 3 levels of intensity.

Rigging the Fixture

Caution

1. The installations must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures if you have doubts concerning the safety do not install.
3. Unit is to be 24inches away from flammable materials decoration material.
4. Use high quality installation equipment to hang unit.

When rigging a unit it is very important that you follow common safety procedures. Rigging requires extensive experience including but not limited to calculating working loads, material being used and periodic safety inspections. If you lack these qualifications, do not attempt the installation yourself, instead use a professional structural rigger. When rigging the unit always be secured with a secondary safety attachment. The installation location of the fixture has got to be built in the way that it can hold 10 times the weight for 1 hour with out any harming. Installation should be checked at least one time a year by a skilled person.

Cleaning and Maintenance

Installation Maintenance: The operator has to make sure that the unit is operating safely and has the installations and electronics checked by an expert every 2 years. The following points have to be considered during the inspection

• All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
• There must not be any deformations on the housing, fixation and installation spots ceiling, suspension, trussing.
• The electronic power supply cables must not show any damages, material fatigue e.g. porous cables or sediments.
• Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any safety problems have to be removed.

Note
There is no serviceable parts inside the device except for the fuse. Maintenance and service operations are to be carried out by authorized dealers.

Replacing the fuse

Only replace the fuse with the same type and rating.

Replacing the power cable

If the power cable of this device becomes damaged, it has to be replaced by authorized dealers or trained professional only. Should you have further questions , please contact your dealer.

Parts List

Warranty Information

Warranty Conditions

• Unless otherwise stated in writing, your product is covered by a one year parts and labor limited warranty.
• LEDs are not guaranteed to match in color temperature or output.
• It is the owner’s responsibility to furnish receipts or invoices for verification of purchase, date, and reseller or distributor.
• If purchase date cannot be provided, date of manufacture will be used to determine warranty period.
• Goods returned under warranty must follow the proper authorization procedure and must be accompanied by a copy of the original invoice.
• Goods repaired under warranty will be returned to the owner with the freight prepaid by MSI via the most economical means of shipment.
• Repair or replacement as provided for under this warranty is the exclusive remedy of the consumer.
• MEGA SYSTEMS INC. makes no warranties, express or implied, with respect to any product, and Mega Systems specifically disclaims any warranty of merchantability or fitness for a particular purpose.
• Mega Systems shall not be liable for any indirect, incidental or consequential damage, including lost profit, sustained or incurred in connection with any product or caused by product defect or the partial or total failure of any product regardless of the form of action, weather in contract, tort including negligence, strict liability or otherwise, and weather or not such damage was foreseen or unforeseen.
• Warranty is void if the product is misused, damaged, modified in any way, or for unauthorized repairs or parts.
• This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Customer Support
Mega Lite has a customer support line to provide set up help and to answer any question should you encounter a prob-lem. Please visit our website for any other related technical documents. For service related issue please contact our service dept. E-mail: service@megasystemsinc.com Please Visit www.mega.lighting for the most up to date.

References

• lite.com
• Concert Touring Lighting | Lighting Consoles - MEGA-LITE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>