Summer Infant 08743Z Snug Support In-Sink Bather User Guide
- June 6, 2024
- Summer infant
Table of Contents
Summer Infant 08743Z Snug Support In-Sink Bather User Guide
WARNING
DROWNING HAZARD: Babies have drowned while using infant bathers.
- STAY in arm’s reach of your baby.
- Use ONLY in empty sink.
- Keep drain open in sink.
- NOT INTENDED FOR USE IN ADULT or INFANT TUBS.
- Never rely on a toddler or preschooler to help your baby or alert you to trouble. Babies have drowned even with other children in or near bath tub.
- Infants can drown in as little as 1 in. (2.5 cm) of water. ALWAYS bathe your infant using as little water as necessary.
FALL HAZARD: Babies have suffered head injuries falling from infant bathers:
-
Place bather ONLY in sink for safe use.
-
NEVER lift or carry baby in the product.
-
STOP using product when baby starts trying to sit up or has reached 20lbs (9.1kg), whichever comes first.
-
NEVER bathe baby until you have tested the water temperature. ALWAYS check water temperature before placing child into product.
-
Bath water should be between 90˚ F and 100˚F (32.2˚C and 37.8˚C).
-
Make sure all the pieces are properly assembled before placing infant in product.
-
NEVER make adjustments or change recline position with child in bather.
Remove child before adjusting or removing product. -
Discontinue use of product if damaged, broken or disassembled.
-
This product is not a toy. DO NOT allow children to play with it.
CARE and CLEANING
CARE AND CLEANING : Unfasten snaps to flatten the pad. Machine wash in cold water, delicate cycle. DO NOT BLEACH. Line dry. DO NOT IRON.
adjusting head support height
Place bather into sink as shown. Place baby onto the infant bather.
-
You may need to adjust the bather head support and recline position depending on the size of your infant. Follow Step 2 and 3 for adjusting head support and recline position
-
Top loops used for smaller size babies / Side loops used for larger size babies
Your head support has two sets of loops for height adjustment. Top loops are for use with smaller size babies. Side loops are for larger size babies.
To secure head support to bather, insert snap strap through the loops on the back of the head support depending on the size of your child and re-fasten strap.
Make sure you use the matching loops on each side of the head support so that they are level.
To remove head support, unfasten snap straps from the loops.
-
There are 3 seat adjustment positions.
To adjust recline postion, unfasten snap and move to different position depending on the size of your infant. ALWAYS make sure you snap the same set of snaps on both sides of the bather so that they adjust the recline angle correctly
Upright Position
Middle Recline Position
Newborn Recline Position
We’re here to help!
If you have any questions or need assistance, contact our Consumer Relations
Team at
1-401-671-6551 or
www.summerinfant.com/contact
Summer Infant (USA), Inc.
1275 Park East Drive
Woonsocket, RI 02895 USA
1-401-671-6551
© 2020 Summer Infant (USA), Inc.
Summer Infant Canada
200 First Gulf Blvd., Unit C
Brampton, Ontario, Canada, L6W 4T5
1-905-456-8484
Colors and styles may vary
Made in China.
Fabriqué en Chine.
D0000000835 01.21
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>