Brydge 12.3 Pro+ Wireless Keyboard User Manual

Brydge 12.3 Pro+ Wireless Keyboard

INSERT /REMOVE

IMPORTANT
Remove non-Brydge screen protectors before attaching your Brydge keyboard This will ensure a perfect fit and eliminate unnecessary pressure to your screen when inserted into the hinges.

TO INSERT: Place your Brydge on a flat surface and set the hinges upright to 90 degrees.
Insert your iPad into the hinges with the home button on the right, one side at a time.
If your iPad is loose. remove it and gently squeeze the hinges Repeat this process until your iPad is held firmly. TO REMOVE: Ensure your Brydge is on a fiat surface.
Place your hand towards the back of the keyboard and pull up, one side at a time.

Power

To manually power on, press and hold Fn + Delete keys. The light will turn green for 2 seconds to indicate power.

To manually power off, press and hold Fn + Delete keys for 2 seconds. The light will blink red momentarily to indicate it’s powered off.

PAIR

1. Turn on your Brydge 12.3 Pro+ (Fn+Del), then press and hold the Bluetooth key for three seconds. The Delete key light will flash blue confirming your Brydge is in pairing mode.

2. On your Surface Pro, select:
   • Start
   • Settings
   • Devices
   • Bluetooth & other devices
   • Add Bluetooth or other device
   • Bluetooth
   • Brydge 12.3 Pro+

3. Type in the PIN on your Brydge 12.3 Pro+ and hit Enter.

NOTE: If pairing takes longer than three minutes, the blue light will stop flashing and you will need to press the Bluetooth button again.

CHARGE

TO CHECK BATTERY LIFE: In Today View, go to the BATTERIES section to check battery life. If not available. swipe left on your Home Screen to show Today View, scroll to the bottom and click edit. Scroll down to Batteries. and click the green ‘+’ icon to add.

NOTE : If battery life is below 15%, backlit key functionality will be disabled to conserve battery.
TO CHARGE: Insert the charging cable into the keyboard and plug the other end into a power source. A solid red LED indicates the Brydge is charging.
When the keyboard is fully charged. the red LED will turn off. A full charge can take up to three hours.

SLEEP/WAKE

To conserve battery, your Brydge will enter sleep mode after 15 minutes of non-use. Press any key to wake it.
When you close your devices together, your Brydge will put your Surface Pro into sleep mode. When you open your devices, your Brydge will wake your Surface Pro.
NOTE: Your Brydge will not put your Surface Pro to sleep or wake it after 15 minutes of non-use.

PRECISION TOUCHPAD

The Brydge 12.3 Pro+ touchpad pairs with your Windows device as a Precision Touchpad, and therefore utilizes all of the Windows touchpad gesture capabilities. To adjust the settings and gestures of your touchpad, select Start > Settings > Devices > Touchpad. The Touchpad can be turned on and off by pressing Fn + Alt.

Keyboard Shortcuts

• Touchpad Disable/Enable
  Fn + Alt (Hold Fn & tap Alt to disable. Hold Fn & tap Alt again to enable.)

• Function Lock
  Fn + Esc / Fn Lock (Hold Fn & tap Esc / Fn Lock to enable and disable function lock.)

• Language Switch
  Win + Spacebar (Use spacebar to toggle through available languages.)

• Help: Fn + F1

• Copy: Command +C

• Paste: Command + V

• Cut: Command + X

• Underline: Command + U

• Italic : Command + I

• Home Screen: Fn + Left Arrow

• Undo: Command+ Z

• Task View: Alt + Tab

• Page Up: Fn + Up Arrow

• Page Down: Fn + Down Arrow

• Home: Fn + Left Arrow

• End: Fn + Right Arrow

Warranty

Thank you for purchasing a Brydge product. This product comes with a 1-year limited hardware warranty on the terms and conditions set out in this document and at www.brydge.com/warranty All Brydge warranties are non-transferrable and are only available to the original end-user of the product. Warranties do not apply to products purchased from on line vendors unauthorized to sell Brydge- branded product. If a defect arises during the warranty period, cease using the product and contact Brydge. To obtain warranty service. visit www.brydge.com/support or call +1 435-604-0481. Brydge. at its sole discretion and option, will (1) repair the product at no charge using new parts or parts that are equivalent to new in performance and reliability or (2) replace or exchange the product with a product of equivalent functionality and value. Brydge offers free return shipping on any approved warranty claims. A shipping label will be provided to you if you are within the United States. If you are outside the United States, Brydge will reimburse your return shipping to a maximum of US$15.00 after providing a copy of the shipping receipt.

Australia Only: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You a re entitled to a replacement or refund for a major fai I u re and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Brydge Technologies LLC I 1912 Sidewinder Dr .. Suite 104. Park City, UT 84060 USA
HAVE A QUESTION? Visit www.brydge.com/support

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation. Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (l) This device may not cause interference. (2) This device must accept any interference. including interference that may cause undesired operation of the device. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the fol lowing two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses. and can radiate radio frequency energy and. if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help

This wireless keyboard (Brydge 11 MAX+. FCC ID: 2ADRG-BRY403, IC: 24378-BRY403) is compatible with the iPad Pro 11-inch (lst generation) (FCC ID: BCGA1980/BGCA2013/BGCA1934, IC: 579C-A1980/579C-A2013/579C-A1934). iPad Pro 11-inch
(2nd generation) (FCC ID: BCGA2068/BGCA2230, IC: 579C-A2068/579C-A2230), iPad Pro 11-inch (3rd generation) (FCC ID: BCGA2377/BGCA2459/BGCA2301/BGCA2460, IC: 579C-A2377/579C-A2459/579C-A2301/579C-A2460) and iPad Air (4th generation) (FCC ID: BCGA2316/BGCA2324/BGCA2325/BGCA2072. IC: 579C-A2316/579C-A2324/579C-A2325/ 579C-A2072).
© 2021 Brydge. All Rights Reserved.
iPad and Apple are registered trademarks of Apple Inc .. registered in the U.S. and other countries.
The Bluetooth word mark. and logos are owned by Bluetooth SIG. Inc. Use of such marks by Brydge is under license. Brydge is a trademark of Brydge Global pte. Ltd. Other trademarks and tradenames are those of their respective owners.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>