BLAUPUNKT Velocity Power BMW Plug & Play Speaker Instruction Manual

BLAUPUNKT Velocity Power BMW Plug & Play Speaker

Proper system planning is vital in order to maximize the device’s performance and road safety. Plan your installation carefully to avoid compromising the performance reliability of the system. Consult an authorized Blaupunkt delaler for installation or reparation. Read the manual carefully before operating the device for the first time.

Safety Notes

Ensure to follow below safety notes during installation and wiring connection:

• Disconnect the negative terminal of the battery. Refer to the safety notes of the vehicle manufacturer.
• Ensure positions of the holes are nowhere near the vehicle component to avoid any damage during drilling.
• Ensure cross-section of the cable is no less than 2.5mm2 if the positive and negative  cables are too long.
• Incorrect installation may result in the malfunction of the device or the car sound system.

Installation and Connection Instructions

• Select a dry and well-ventilated location to install the device.
• The device must not be installed in overly exposed location such on there ar shelf, rear seat etc.
• The installation location must be suitable for screw holes and have stable ground support.

Disclaimer

In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products. USA & CANADA: This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada.

Voltage Supply

• Use the supplied power extension cable to connect to the positive battery terminal.
• Firmly and carefully connect the ground lead to a bare metal point on the vehicle chassis.
• The control of the device should be a two-channel control, either via the preamplifier output of the car sound system.
• A control solely via the right or left channel is also possible since the low-frequency portion of the music is generally identical on both channels.

Recycling and Disposal

Do not dispose of your old unit in the household trash! Use the return and collection systems available to dispose of the old device. This manual may be updated from time to time without any notice.

SPECIFICATION

BM 1420 CM4
Pair of 4” BMW direct fit plug & play subwoofer to upgrade OE speaker installed for selected BMW models with paper cone material including installation instruction.

• Normal output power (RMS) : 30W Max. output power : 60W
• Sensitivity : 86dB
• Impedance : 4ohms
• Frequency response : 80Hz – 20,000Hz Surround : Rubber
• Magnet type : Neodymium magnet Mounting depth : 39mm
• Diameter hole : 129.5mm
• Overall height : 55mm

BM 1420 CU4
Pair of 4” BMW direct fit plug & play subwoofer to upgrade OE speaker installed for selected BMW models with paper cone material including installation instruction.

• Normal output power (RMS) : 30W Max. output power : 60W
• Sensitivity : 86dB
• Impedance : 4ohms
• Frequency response : 80Hz – 20,000Hz Surround : Rubber
• Magnet type : Neodymium magnet Mounting depth : 44.5mm
• Diameter hole : 114.3mm
• Overall height : 55mm

INSTALLATION

Mid-range speakers

1. Carefully remove the trim piece with the help of door trim removal to prevent damage
2. Lift up the trim piece before slowly slide outward to re-lease the trim from the door panel as seen in photograph
3. Remove the door handle
4. Note that the door panel is fixed by numerous plastic clips, carefully pull the door away and disconnect all wiring doorlatch cables. Be very careful to avoid the damage of the plastic clips during door panel removal
5. Remove front door card
6. Remove all 3 screws that hold the mid-range speaker
7. Side by side comparison of OE speaker and Blaupunkt speaker
8. Install Blaupunkt speaker using the original screws

Tweeter

1. Carefully remove original tweeter housing. (Wind down window for easy installation)
2. Replace the tweeter and insert the foam to the triangle housing. (Door triangle housing has speaker grill and holder for tweeter which is not included in the Blaupunkt speaker)
3. Finally, reconnect the wirings and door latch cables, ressemble the removed parts back on to the door and tighten the door panel’s screw firmly.

COMPATIBILITY LIST

BM 1402 CM4

Series  Model               Model Year Mounting Position|  | Series Model                                   Model Year| Mounting Position
---|---|---|---
1 series E81(3-door)| 2004-2013| Front door|  | 5 series F10 (Limousine) 2010-2014| Front door/ Rear door
E82 (Coupé)| 2004-2013| Front door|  | F11 (Touring) 2010-2014| Front door/ Rear door
E87 (5-door)| 2004-2013| Front door|  | 6 series E63 (Coupé) 2002-2007| Front door/ Rear side panel

BM 1402 CU4

Documents / Resources

| BLAUPUNKT Velocity Power BMW Plug & Play Speaker [pdf] Instruction Manual
BLAUPUNKT, Velocity, Power, BMW, Plug Play, Speaker, BM 1402 CM4, BM 1402 CU4
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>