LiftMaster R11 Garage Door Remote User Guide
- October 27, 2023
- LiftMaster
Table of Contents
LiftMaster R11 Garage Door Remote
INSTRUCTIONS TO PROGRAM A REMOTE
- Press and release the learn button on the back of the motor unit. The light will illuminate for 30 seconds. This indicates the unit is in programming mode
- Within 15 seconds press the button you wish to program on the remote control.
- You will hear an audible click and/or the light on the motor unit will turn off indicating the remote successful programming. Repeat steps 1-3 for any additional remotes you wish to program. Wait 60 seconds before programming another remote control.
INSTRUCTIONS TO ERASE ALLcODES FROM MEMORY
Press and hold the purple learn button on the back of the motor unit for 6 seconds or until the light turns off.
WARNING
In order to prevent possible SERIOUS INJURY or DEATH from a moving gate or
garage door keep remote controls out of the reach of children. Only use the
remote control when the gate garage door can be seen dearly, is properly
adjusted, and there are no obstructions to door travel. Keep the gate garage
door in sight until it is completely closed. Do not allow anyone to cross
paths with the gate/garage door while moving or operating the remote control.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>