SALUS RE600 Amplifier Signal Repeater User Guide

June 6, 2024
SALUS

SALUS RE600 Amplifier Signal Repeater User Guide
SALUS RE600 Amplifier Signal Repeater

Introduction

SALUS RE600 is a product that is used as a booster to extend Zigbee devices communication range. It can be installed directly within a wall box or surface mounted onto the wall using the supplied wall bracket. This product must be used with the SALUS UGE600/UG600 (purchased separately). The SALUS UGE600/UG600 allows communication with other SALUS Smart Home products using the SALUS Smart Home App.

Product Compliance

This product complies with the essential requirements and other relevant provisions of Directives 2014/53/EU (RED) and 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.saluslegal.com. 2405-2480MHz; <14dBm

Safety information

Use in accordance with the regulations. Indoor use only. Keep your device completely dry. Disconnect your device before cleaning it with a dry cloth. This accessory must be fitted by a competent person, and installation must comply with the guidance, standards and regulations applicable to the city, country or state where the product is installed. Failure to comply with the relevant standards could lead to prosecution.

Terminals

  • Live 230V AC
  • Neutral 230V AC

Wiring

Box content

  • Smart repeater

  • Wall mounting bracket

  • Fixing kit

  • Quick Guide
    Box Items

Mounting

Mounting

LED Indication

Description

| LED
---|---
Joining Network automatically|

RED LED pulsing

Joining Network trigger by button press|

RED+GREEN LED turn on for 1 second, then RED LED pulsing

Device with Network|

RED LED

Device without Network or loss link

| RED LED pulsing
Identify|

GREEN LED flashing for up to 10 minutes

Pairing

Once powered, the LED will flash red to indicate pairing mode

Pairing Induction
Pairing Induction
Pairing Induction
Pairing Induction

Remove

Remove Induction Remove
Induction

Button operation

  • To identify the device, short press the button.
  • To enter pair mode, press and hold the button for 3 seconds.
  • To do a factory reset, press and hold the button until LED flashes red (max 15 sec).
    Button operation

www.salus-controls.eu
www.sysclima.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals