SALUS Smart Button SB600 User Guide
- June 6, 2024
- SALUS
Table of Contents
SALUS Smart Button SB600
Introduction
The Smart Button is used to trigger the “One touch” and “My Status” rules that you have created for your Salus Smart Home system . Normally “One touch” and “My Status rules are triggered via the Salus Smart Home app, however the Smart Button provides an additional Method. This product must be used with the Universal Gateway (UG600/UGE600) and the Salus Smart Home App. Go to www .salus-smarthome.com for the PDF version of the manual.
Product Compliance
This product complies with the essential requirements and other relevant provisions of Directive 2014/30/EU, 2014/35/EU, 2014/53/EU and 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.saluslegal.com.
Installation
During initialisation, the LED lights up for 2 seconds, then will flash until the network is found (max 20 times). When joined the LED will go off.
Follow the on screen instructions. Once connected, the LED will stop flashing.
Factory Reset
Remove one battery. Keep the reset button pressed when inserting back the battery.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>