SALUS Coordinador ZigBee CO10RF Instruction Manual
- June 6, 2024
- SALUS
Table of Contents
SALUS Coordinador ZigBee CO10RF
Note!
Don’t use CO10RF coordinator with UGE600 simultaneously!
Introduction
CO10RF coordinates the iT600RF series devices in Offline mode and it is nec- essary to create a ZigBee network. CO10RF provides wireless control of all devices in the iT600RF system. One CO10RF can handle up to 30 thermostats, 8 wiring centres and 90 radiator valves. If there are more than 32 battery powered devices in the iT600RF network (eg. thermostats, radiator valves) or distances between devices cause network range problems, the system must be equipped with an additional RE10RF repeater.
Product Compliance
EU Directives: 2014/30/EU, 2014/53/EU, 2011/65/EU.
Full information is available on the website www.salus-
controls.eu
Safety Information
Use in accordance with the regulations. Indoor use only. Keep your device completely dry. Disconnect your device before cleaning it with a dry cloth.
Description
ZigBee network is ready to accept iT600RF devices
CO10RF works in Offline mode
Checking system configuration
Installation
-
Attach CO10RF coordinator to USB adaptor or KL08RF wiring centre.
-
Power up
-
To commence system installation press and hold the button for 5 seconds untill button starts flashing red. This means the ZigBee network is ready to accept iT600RF devices.
Note: It’s highly recommended to refer to individual devices manuals before starting installation process for each of them.
-
When everything is paired press and hold button for 5 seconds or till the flashing stops. If you want to replace or add iT600RF devices please en-sure you follow steps 3 to 4.
Checking system configuration
To check which devices of the iT600RF system are paired and have been configured correctly, you can use Identify mode. Press the button to activate Identify mode. Using Identify mode the CO10RF will show all equipment that is connected to your system. Press the button again to cancel Identify process. Identify mode will time out after 10 minutes.
Factory Reset
Choosing a factory restore results in erasing all saved setting and removing
connected equipment from the system. Press and hold button for 15 seconds, if
you want to use a factory restore. When the process is completed, LED light
will flash continuously.
DISTRIBUTOR de SALUS CONTROLS: Sysclima.
Sistemas y Soluciones Climáticas. Polígono La Serna Calle C, Nave 6.14 31500 –
TUDELA – Navarra ESPAÑA
IMPORTER:
QL CONTROLS Sp. z o.o. Sp. k.
ul. Rolna 4, 43-262 Kobielice
PRODUCER:
Salus Limited
6/F, Building 20E, Phase 3, Hong Kong Science Park, 20 Science Park East
Avenue, Shatin, New Territories, Hong Kong
www.salus-controls.eu
www.sysclima.com
SALUS Controls es miembro del Grupo Computime.
Este manual se ha realizado con la intención de ofrecer a los clientes unas
instrucciones claras y sencillas.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>