SALUS UGE600 Gateway Installation Guide

SALUS UGE600 Gateway

Introduction

The Universal Gateway is the key product for the SALUS iT600 system. This will offer you the possibility to wirelessly control all the connected equipment just by using your smartphone or your computer via the Internet. You can connect up to 100 devices to one gateway. Go to www.salusmanuals.com for the PDF version of the manual.

Product Compliance

This product complies with the essential requirements and other relevant provisions of Directives 2014/30/EU, 2014/35/EU, 2014/53/EU and 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.saluslegal.com.

Devices that can be connected

Description of the UGE600

Installation in Online mode

(with Internet connection via SALUS Smart Home app)

Power up

This product must be used with the SALUS Smart Home App.

Sign up, create an account and confirm it. After that please Sign in

Follow the on screen instructions

• Success! You have connected your gateway. Press to go to the Dashboard.

Connect your UGE600 via WiFi (optional)

First add the UGE600 on the APP by using the Enthernet cable (steps 1 – 6). Create the WiFi settings (steps 7 – 13), wait 2 min and remove the Enthernet cable.
WiFi SSID: the name of your network (Case sensitive)
WiFi Password: the password of your network
Note: The WiFi Internet connection might not be as stable as the one on cable.

Checking system configuration

To check which devices of the iT600 system are paired and have been configured correctly, you can use Identify mode. Press the button to activate Identify mode. Using Identify mode the UGE600 will show all equipment that is connected to your system. Press the button again to cancel Identify process. Identify mode will time out after 10 minutes.

Installation in Offline mode

(without an Internet connection)

To commence system installation press and hold the button for 5 seconds untill button starts flashing red. This means the ZigBee network is ready to accept iT600 devices.

Note: It’s highly recommended to refer to individual devices manuals before starting installation process for each of them.
When everything is paired press and hold button for 5 seconds or till the flashing stops. If you want to replace or add iT600 devices please ensure you follow steps 2 to 4.

Factory Reset

Choosing a factory restore results in erasing all saved setting and removing connected equipment from the system. Press and hold button for 15 seconds, if you want to use a factory restore. When the process is completed, LED light will flash continuously.

Online/Offline

Documents / Resources

| SALUS UGE600 Gateway [pdf] Installation Guide
UGE600, Gateway, UGE600 Gateway
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>