SALUS Smart Relay SR600 User Guide
- June 6, 2024
- SALUS
Table of Contents
- SALUS Smart Relay SR600 User Guide
- Introduction:
- Product Compliance:
- Safety Information:
- Wiring diagram
- Terminals
- Pairing Process
- 9..Follow the onscreen
- LED Indication
- EN Remove device
- S1&S2 terminals
- Button operation
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SALUS Smart Relay SR600 User Guide
Introduction:
Smart Relay (SR600) is a switching relay product that can be used to power on
or off a maximum 16A load. It can be installed directly within a wall box or
surface mounted onto the wall (using the optional SRS600 wall mount bracket).
This product must be used with the Universal Gateway (purchased separately).
The Universal Gateway allows communication with other SALUS Smart Home
products using the SALUS Smart Home App.
Product Compliance:
This product complies with the essential requirements and other relevant
provisions of Directives 2014/53/EU (RED) and 2011/65/EU. The full text of the
EU Declaration of
Conformity is available at the following internet address: www.saluslegal.com.
2405-2480MHz; <14dBm
Safety Information:
Use in accordance with the regulations. Indoor use only. Keep your device
completely dry. Disconnect your device before cleaning it with a dry cloth.
This accessory must be fitted by a competent person, and installation must
comply with the guidance, standards and regulations applicable to the city,
country or state where the product is installed. Failure to comply with the
relevant standards could lead to prosecution
Wiring diagram
Terminals
| COM | Common terminal |
|---|---|
| NO | Switch terminal |
| L | Power supply 230V AC |
| N | Power supply 230V AC |
| S1/S2 | Switch input terminals |
Pairing Process
9..Follow the onscreen
LED Indication
| Description | LED |
|---|---|
| Joining Network automatically | RED LED pulsing |
| Joining Network trigger by button press | RED+GREEN LED turn on for 1s, then |
RED LED pulsing
Device Relay ON with Network| GREEN LED ON
Device Relay OFF with Network| RED LED ON
Device Relay OFF without Network| RED LED pulsing
Device Relay ON without Network| RED + GREEN LED pulsing
Identify| GREEN LED flashing for up to 10 minutes
EN Remove device
S1&S2 terminals
Button operation
To identify the device, short press the button.
To enter pair mode, press and hold the button for 3 seconds.
To do a factory reset, press and hold the button until LED flashes red (max 15
sec).
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>