SALUS Battery Powered Motion Sensor MS600 User Guide
- June 6, 2024
- SALUS
Table of Contents
SALUS Battery Powered Motion Sensor MS600
SALUS Controls is a member of the Computime Group.
Maintaining a policy of continuous product development SALUS Controls plc
reserve the right to change specification, design and materials of products
listed in this brochure without prior notice.
For PDF Installation guide please go to www.salus-manuals.com
Issue Date: 01 2021
Introduction
MS600 is a battery powered motion sensor that can detect movement. It supports the pet immunity up to 36 kg and its detection distance is up to 8 meters. This product must be used with the Universal Gateway (UG600/UGE600) and the Salus Smart Home App .
Product Compliance
This product complies with the essential requirements and other relevant
provisions of Directives 2014/53/EU (RED) and 2011/65/EU. The full text of the
EU Declaration of Conformity is available at the following internet address:
www.saluslegal.com. 2405-2480MHz; <10dBm
Safety Information
Use in accordance with the regulations. Indoor use only. Keep your equipment completely dry. Disconnect your equipment before cleaning it with a dry towel.
Technical Specification
| T echnic al S pecific a tion | |
|---|---|
| Detection Angle/Distance/ Technology | 80 degrees/ 8 meters/ PIR |
| Pet Immune | ~ 36 kgs |
| Mounting Height | 1.9 to 2.3 m |
| Protocol | ZigBee 3.0: 2.4GHz |
| Battery Life/Type | ~ 3 Years/ 1x CR123A |
| Operating Temperature | 0°C ~ 40°C |
| Operating Humidity | Up to 85%, Non-condensing |
| Operating Range | ~40 m Open Field |
| Certifications | CE |
Note: A passive infrared sensor (PIR sensor) is an electronic sensor that measures infrared (IR) light radiating from objects in its field of view.
Dimensions
Power up & Pairing
Follow the onscreen instructions up to “Finish”.
MS 600 LED Indicator: If sensor has not been added to gateway, the LED will be blinking about one time per second. The LED will turn off when joined to gateway successfully.
Activated
Deactivated
The sensor will change its status from deactivated to activated when movement is detected. To turn ON/turn OFF other Smart Home devices dependent on the MS600 motion sensor (or receive an SMS/email notification) create a One Touch rule in the OneTouch menu of the App.
Positioning
The Motion Sensor should be placed in a corner of the room with a view of each
entry point. For an accurate motion detection, there should be no obstacles in
front of the product’s lens. The mounting height must be between 1.9 m and 2.3
m.
Install the motion sensor by removing
the bracket.
Note: This product has low voltage detection reminder, when the battery
voltage is in low status, the detector will give out low battery signal to the
app. Replace the battery timely on low battery warning to ensure the detector
works properly. If you don’t use this product for a long time, please remove
the battery for safe keeping.
Factory Reset
Press the reset button for 3 seconds then release the pin to
reset the sensor. After the reset, the sensor will be found by the App or the
gateway when they search for the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>