GRANDSTREAM GUV3050 Bluetooth Headset User Guide

GRANDSTREAM GUV3050 Bluetooth Headset

Grandstream Networks, Inc.
126 Brookline Ave, 3rd Floor
Boston, MA 02215 USA
Voice: 617-566-9300
Fax: 617-249-1987
www.grandstream.com

For Warranty and RMA information, please visit www.grandstream.com

PRECAUTIONS

• Always store the headset with the power off and safely protected.
• Do not expose this device to temperatures outside range of -10° to 40° for operating and -20° to 50° for storage.
• Avoid using the headset for too long and/or with high volume, this may affect the hearing.
• Use a recommended adapter to charge.
• Dispose of batteries according to local laws & regulations. Please recycle if possible. Do not dispose of the batteries as household garbage or into the fire to avoid explosion.
• Do not attempt to remove or replace the battery on their own. Such operations may damage the device.

PACKAGE CONTENTS

HEADSET COMPONENTS

WEAR THE GUV3050 HEADSET

1. GUV3050 BT headset can be worn only on the right.
2. Adjust the Headband.
3. Adjust the headband until it is comfortable, ideally ensuring that there is virtually no pressure felt on the ears.

CONNECT THE GUV3050 HEADSET

1. Ensure that the headset is switched on.
2. Connect the BT dongle into an USB port on your PC. The headset and BT dongle are already pre-connected.
3. Hold the On/Off/Connect switch in the connect position for 2 seconds until you hear the voice guided instruction. The Bluetooth indicator will flash in blue.
4. Follow the voice guide instruction to connect.

CHARGE THE BATTERY

Option 1: The headset battery can be charged when connected to a PC using an USB cable (provided), or using any micro-USB charger (not provided).
Option 2: Plug the charging base into a powered USB port and then dock the headset.

HOW TO USE THE HEADSET

succession
Headset off| Slide the Off switch| Red light flash once in succession
Pairing| Slide the Pair Button| Blue Light flash
Pairing Successfully|  | Green light flash twice and blue light flash

once in succession

Standby|  | Blue light flash 1 time per 8 secs
Adjus t V olume| Tap the Volume UP or Volume Down Button|
Answer/En d Call| Tap the Multi-function button|
Redial/Reject Call| Double-tap the Multi- function button|
Mute/Unmute Microphone| Press and hold (2 secs) the volume down button|

HOW TO MANAGE MULTIPLE CALLS

Rejec t incoming call , when on a call| Double-tap the Multi-function button
---|---
End curren t cal l and answe r incoming call| Tap the Multi-function button
Put curren t cal l on hold and answe r incoming call| Press and hold (2 secs) the volume down button
Switch between held call an d activ e call| Press and hold (2 secs) the volume down button

CERTIFICATION INFORMATION

Common part:
This equipment complies with radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

U.S. FCC Part 15 Regulatory Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Canada Regulatory Information
This device complies with Innovation, Science, and Economic Development Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.

The device is compliance with RF exposure guidelines, users can obtain Canadian information on RF exposure and compliance.

Canada Regulatory Information
Support Frequency Bands and Power:
BT_BR+EDR < 2dBm
BT_BLE < 2dBm
The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as follows:
Hereby, [Grandstream Networks, Inc.] declares that the radio equipment type [GUV3050] is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.grandstream.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>