vtech Fire Rescue Cory Instructions

June 6, 2024
vtech

Vetch **Fire Rescue Cory Instructions

**

INSTRUCTIONS

Unlock the Packaging Locks

  1. Rotate the packaging lock counterclockwise several times.
  2. Pull out the packaging lock and discard.

Battery Removal and Installation

  1. Make sure the unit is turned Off.
  2. Find the battery cover located on the bottom of the unit, use a screwdriver to loosen the screw and then open the battery cover.
  3. Remove old batteries by pulling up on one end of each battery.
  4. Install 3 new LR44 batteries following the diagram inside the battery box.
  5. Replace the battery cover and tighten the screw to secure.
    Battery Instructions

WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.

NOTE: Please keep this parents’ guide as it contains important information.

IMPORTANT: BATTERY INFORMATION

  • Insert batteries with the correct polarity (+ and -).
  • Do not mix old and new batteries
  • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
  • Only batteries of the same or equivalent type as recommended are to be used.
  • Do not short-circuit the supply terminals.
  • Remove batteries during long periods of non-use.
  • Remove exhausted batteries from the toy.
  • Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES

  • Remove rechargeable batteries from the toy before charging
  • Rechargeable batteries are only to be charged under adult supervision.
  • Do not charge non-rechargeable batteries.

Symbol

| Meaning
---|---
| Warning: contains coin battery
| Read parents’ guide

WARNING
This product contains one or more button cell or coin batteries. If swallowed, a button cell or coin battery can cause internal chemical burns in as little as two hours and can lead to death. Dispose of used batteries immediately. Keep new and used batteries away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention, and go straight to the nearest hospital emergency department.

Australia/New Zealand
If you think batteries might have been swallowed or placed inside any part of the body, immediately call the 24-hour Poisons Information Center on 13 11 26 (in Australia) or 24-hour National Poisons Centre on 0800 764 766 (in New Zealand) for fast, expert advice and go straight to the nearest hospital emergency room.

WARNING:

  • Adult assembly required for battery installation
  • Keep batteries out of reach of children.

PRODUCT FEATURES

  1. On/Off Switch
    To turn the unit On, slide the On/Off Switch
    to the On position. To turn the unit Off,
    slide the On/Off Switch to the Off  position.

  2. Automatic Shut-Off
    To preserve battery life, the Go! Go! Cory Carson® character will
    automatically power down after approximately 30 seconds without input.The unit can be turned on again by pressing the Light-Up Button, placing the accessory on or removing the accessory from the character or by rolling the character quickly.

NOTE: This product is in a Try-Me mode in the packaging. After opening the packaging, turn the character Off and On again, or before the product goes into sleep mode, put the accessory on top of the character for more than 2 seconds to proceed with normal play. If the unit powers down while playing, we suggest changing the batteries.

ACTIVITIES

  1. Light-Up Button
    Press the Light-Up Button to hear sounds, songs, phrases and melodies. The light will flash with the sounds.

  2. Stacking Fun
    Place the accessory on the character’s back to unlock new phrases and fun content. The lights will flash with the sounds.

  3. Sounds and Melodies
    Push to hear fun sounds. If a melody is already playing, push the character to add fun sounds on top of the melody. The light will flash with the sounds.

CARE & MAINTENANCE

  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from any direct heat sources.
  3. Remove the batteries if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

  1. Turn the unit Off.
  2. Interrupt the power supply by removing the batteries.
  3. Let the unit stand for a few minutes, then replace the batteries.
  4. Turn the unit On. The unit should now be ready to use again.
  5. If the unit still does not work, install a new set of batteries.

IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department
at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to
our website vtechkids.com and filling out our Contact Us form located
under the Customer Suppor t link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning  the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

  • Trade Name: VTech®

  • Model: 5451

  • Product Name: Go! Go! Cory Carson® Fire Rescue Cory™

  • Responsible Party: VTech Electronics North America, L.L.C.

  • Address: 1156 W. Shure Drive, Suite 200,
    Arlington Heights, IL 60004

  • Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. CAN ICES-003(B)/NMB-003(B)

Contact us

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com
vtechkids.ca

Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty

TM & © 2020 VTech Holdings Limited.
All rights reserved.
PrintedinChina.
91-003791-017 US

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals