NUX DFU MG-30 Firmware Update User Guide
- June 6, 2024
- NUX
Table of Contents
MG-30 Firmware Update Guide
Download the firmware
-
Visit https://www.nuxefx.com/mg-30.html using your preferred broswer.
-
Scroll the page down a little bit , click the Support tag to jump down to the Support section of the product page. This is where you can find the documentations, new
firmware, editor software and drivers etc.
-
Download either the Windows or Mac firmware update kit depending on your operating system.
-
Unzip the downloaded file, you should can see a folder containing one “NUX Device Updater” and a .bin file(firmware itself).
Connect MG-30 to your computer & Active the update mode.
-
Connect MG-30 to your computer using the included USB-C cable.
-
Run “NUX DFU Updater”
-
Press and hold down both the Down and Up foot-switches while turning on the power switch, release the foot-switches until you see “Device Firmware Update” on MG-30’s display; the “NUX DFU Updater” should now indicates “Device Connected”
Updating the firmware.
-
Select the new firmware bin file; Click “Start Update” button to proceed.
-
Wait until the progress ends.
WARNING: DO NOT Unplug the USB-C Cable nor the Power Supply during the update.
-
When the firmware update process is complete, close “NUX DFU Updater”, disconnect the USB-C cable and turn off the power switch.
If you have any problem, please feel free to contact us by email. info@cherubtechnology.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>