HOLMAN EVIE Rain Sensor User Guide
- June 6, 2024
- Holman
Table of Contents
EVIE Rain Sensor
User Guide
The following instructions highlight how to re-pair your EVIE Sensor to the WX8 :
-
Bring your EVIE Sensor to your WX8 irrigation controller so that you can operate both devices simultaneously
-
On the EVIE Sensor, remove the rubber plug (A) on the underside and check there are two CR2032 batteries (B) installed
-
On your WX8, turn the dial to OFF (C)
-
Press and hold START for 5 seconds (D) until the LEDs of ZONE 1 and 2 both flash, alternating between red and blue (for 20 seconds only)
The next step must be completed in the first 20 seconds while the LEDs are still flashing
If you run out of time it is possible to attempt the process again -
On the EVIE Sensor, press and hold the internal button (E) until the WX8 LEDs of ZONE 3 and 4 are alight
If the pairing succeeds, these LEDs will be blue
If the pairing fails, these LEDs will be red -
After pairing is successful, on the WX8, turn the dial to RUN to exit the pairing mode
-
Wait at least one minute for the Holman Home to show EVIE Sensor is connected to the WX8 in the DEVICE INFORMATION screen (F)
-
Replace the rubber plug back into EVIE Sensor (A)
For additional pairing help, please visit https://www.holmanindustries.com.au/ to access additional support pages or contact our Customer Service team
For additional help, visit https://www.holmanindustries.com.au/
For the # SMARTGARDENER
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>