PHILIPS LL500E H4 Gen2 Maxos Fusion Installation Guide
- October 30, 2023
- Philips
Table of Contents
Maxos Fusion
LL500E Gen2
Installation Guide
LL500E H4 Gen2 Maxos Fusion
- for use with SR drivers
- one sensor can support Max 4 drivers. DALI line needs to be interrupted after max 4 drivers
- use the supplied T2T connector to electrically separate group of 1 sensor + 4 drivers with another group along the line
PIR occupancy sensing
Notes
The white areas are blind spots and the detection is based on the motion of
the subject. An idle subject may not continue to trigger occupancy detection
once the hold time expires. As PIR based sensing works on temperature
difference between the subject and the ground level, the occupancy detection
could vary due to clothing and size of the subject.
|
---|---
You must have a lighting plan, if you install the warehouse system.| Do not
install the warehouse system control unit close to steel or concrete
constructions.
| 
| Do not block the view of the warehouse system sensor.
442710472830
2023-03-07
© Signify Holding
All rights reserved
Printed in Poland
Data subject to change without notice
Keep for future reference:
www.philips.com/lighting
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>