vtech Marble Rush Adventure Set 72cm User Guide
- June 6, 2024
- vtech
Table of Contents
vtech Marble Rush Adventure Set 72cm
We aim to reduce our environmental impact and have reduced the amount of paper
used for our printed manuals. The full version of the manual is available
online through the following link or by scanning the QR code.
vtechkids.com/guides
WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
GETTING STARTED
Battery Removal and Installation
-
Make sure each unit is turned Off.
-
Find the battery cover located on the back of each unit, use a coin or screwdriver to loosen the screws and then open each battery cover.
-
Remove old batteries by pulling up on one end of each battery.
-
Install 2 new AA (AM-3/LR6) and 3 new AAA (LR03/AM-4) batteries following the diagrams inside the battery boxes. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
-
Replace the battery covers and tighten the screws to secure.
IMPORTANT: BATTERY INFORMATION
- Insert batteries with the correct polarity (+ and -).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not short-circuit the supply terminals.
- Remove batteries during long periods of non-use.
- Remove exhausted batteries from the toy.
- Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
- Remove rechargeable batteries from the toy before charging.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not charge non-rechargeable batteries.
WARNING:
CHOKING HAZARD -Toy contains small parts and small balls.
Not for children under 3yrs.
WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children.
LABEL APPLICATION
Please securely stick the labels to the playset as indicated below:
CARE & MAINTENANCE
- Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heatsources.
- Remove the batteries if the unit will not be used for an extended period of time.
- Do not drop the unit on hard surfaces or expose the unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working, please follow these steps:
1. Turn the unit Off. 2. Interrupt the power supply by removing the batteries. 3. Let the unit stand for a few minutes, then replace the batteries. 4. Turn the unit On. The unit should now be ready to play again. 5. If the unit still does not work, install a brand new set of batteries.
IMPORTANT NOTE: If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.
Note
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. -
Consult the dealer or an experienced radio/TV technician for help.
CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5423
Product Name: Marble Rush™ Ultimate Set™
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200, Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>