vtech 545400 Go Go Cory Carson The Carson Playhouse User Guide

vtech 545400 Go Go Cory Carson The Carson Playhouse

INTRODUCTION

Thank you for purchasing the Go! Go! Cory Carson® The Carson Playhouse™!
Get ready to play with Cory and Chrissy in their playhouse. Place the mini characters on the PlayZone™ location to hear fun phrases and sounds. Then, press the mailbox to launch the character.

INCLUDED IN THIS PACKAGE

• One label sheet
• One parent’s guide

WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.

NOTE: Please keep this parent’s guide as it contains important information.

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Locate the battery cover on the bottom of the playhouse. Use a screwdriver to loosen the screw.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the diagram inside the battery box.
5. Replace the battery cover and tighten the screw to secure.

BATTERY NOTICE

• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc), rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity (+ and -).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if removable).
• Rechargeable batteries are only to be charged under adult supervision.

WARNING: Adult assembly required for battery installation.
Keep batteries out of reach of children.

LABEL APPLICATION

Please securely stick the labels to the playset as indicated below:

ASSEMBLY INSTRUCTIONS

With the The Carson Playhouse™, safety comes first. Adult assembly is required. For your child’s safety, do not let them play with this toy until it is fully assembled.

1. Place the Base on a flat surface and insert the House into the Base. Press down firmly, the house will click into place. Insert the Halle Piece into the House.
2. Connect the Tire Swing to the Tree and then insert the Tree into the Tree Base.
3. Connect the Seesaw to the Seesaw Base.Playset may be configured in a variety of ways:
4. Connect the Tree and the House with the Ramp tack as shown on the left. Or connect the Tree to the House as shown on the right.

Once you’ve completed the above steps, you are ready to play! Mini characters from other sets (each sold separately) are also compatible.

PRODUCT FEATURES

1. On/Off Switch
   To turn the unit On, slide the On/Off Switch to the On position. To turn the unit Off, slide the On/Off Switch to the Off position.

2. Automatic Shut-Off
   To preserve battery life, The Carson Playhouse™ will automatically power down after approximately 45 seconds without input. The unit can be turned on again by pressing the Mailbox Launcher or triggering the PlayZone™ with the mini characters.
   NOTE: If the unit powers down while playing, we suggest changing the batteries.

ACTIVITIES

1. PlayZoneTM Location
   Place Mini Cory, Mini Chrissy or other Go! Go! Cory Carson® mini characters (sold separately) on the PlayZone™ Location to trigger fun phrases and sounds from the show. The characters will flash with the sounds.

2. Mailbox Launcher
   When a mini character is on the PlayZone™ Location, press the Mailbox Launcher to flip open the garage door and launch the mini character over the Ramp Track.

SONG LYRICS

1. Oh our house is a home, And we’re never alone, Love and laughter will lead the way!
2. I like challenges, Yeah, woohoo! Let’s play on the seesaw.

MELODIES

1. Hickory Dickory Dock
2. I Want to Go Back to Michigan
3. Man on the Flying Trapeze
4. Listen to the Mockingbird
5. Here We Go Round the Mulberry Bush
6. Entertainer

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat source.
3. Remove the batteries if the unit will not be in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.

IMPORTANT NOTE: If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Supplier’s Declaration of Conformity

47 CFR § 2.1077 Compliance Information

Trade Name: VTech®
Model: 5454
Product Name: Go! Go! Cory Carson® The Carson Playhouse™
Responsible Party: VTech Electronics North America, LLC Address: 1156 W. Shure Drive, Suite 200 Arlington Heights, IL 60004
Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)

Visit our website for more information about our products, downloads, resources and more.
www.vtechkids.com
www.vtechkids.ca

Read our complete warranty policy online at
www.vtechkids.com/warranty
www.vtechkids.ca/warranty

TM & © 2020 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-003946-000 US CA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>