enbrighten 48372 USB-Powered Color Changing Lights User Manual

: June 6, 2024
: enbrighten

Table of Contents

Installation
Power (sold separately)
Control
Troubleshooting
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

48372 USB-Powered Color Changing Lights
User Manual

READ IT OR WATCH IT
Read instructions or watch easy-to-follow video.
Scan QR code or visit http://bit.ly/36wUeNf

https://byjasco.com/hep-et/20000-99999/48372/manual

Installation

Hang your Ecoscapes USB-Powered String Lights by utilizing the built-in keyhole mounting tabs located above each bulb.
Use nails, screws, hooks, or guide wires to mount/hang the lights in your preferred indoor or outdoor location.

Power (sold separately)

Power the lights using the USB connector via any standard USB 5.0V (500mA minimum) power source. These include in-wall USB ports, standard USB power adaptors, and mobile USB power banks.
This product can also be powered by the Enbrighten Solar Panel (49582) which is available at byjasco.com or amazon.com.

Control

Operate the lights with the attached remote by selecting one of the following buttons:

POWER: Turns the lights ON/OFF
4HR: Internal timer deactivates lights after four hours.
To activate the 4-hour timer, press the button and lights will flash to indicate that timer has been activated.
6HR: Internal timer deactivates lights after six hours.
To stop the activated timer, press the power button to turn off the device.
MODE: Cycles through the following color modes

• Warm White Light
• Color Fade
• Red Light
• Green Light
• Blue Light| • Yellow Light
• Purple Light
• Pink Light
• Orange Light
• Turquoise Light| • Christmas Holiday
• Red, White, and Blue
• Rainbow
• Twinkle
---|---|---

Additional Accessories
Available at byjasco.com or amazon.com

Troubleshooting

Problem	Possible Cause	Solution
No lights or flashing lights	Poor USB connection	Check the USB plug and

socket for dirt or foreign matter, and ensure the plug is inserted firmly in place.
Won’t turn on| Please ensure that the output voltage of the power supply is 5V and the available current is not less than 500mA. When using a 5V power bank, make sure that there is the power to the light. When using a solar-powered panel, be sure that the solar panel is turned “ON”.
Power mismatch| When the USB power voltage is too high or the current is not enough, it may cause the lights to flicker. Excessive
voltage may lead to product damage.
Contact our U.S.-based Consumer Care at 1-800-654-8483 between 7 AM-8 PM CST.

WARNING

RISK OF ELECTRIC SHOCK

RECEPTACLE OUTLETS USED FOR POWERING CAFÉ LIGHTS SHALL COMPLY WITH ALL NATIONAL AND LOCAL ELECTRICAL CODES. CONSULT LOCAL ELECTRICIAN IF UNSURE OF COMPLIANCE REQUIREMENTS.
DO NOT SUBMERGE.
DO NOT USE AROUND AQUARIUMS.
CAFÉ LIGHTS ARE A WET LOCATION PRODUCT AND HAVE NO SERVICEABLE PARTS.
AVOID DAMAGE TO THE CORDS AND LAMP ASSEMBLIES DURING INSTALLATION. PERIODICALLY INSPECT THE CAFÉ LIGHTS FOR PHYSICAL DAMAGE OR OTHER DAMAGE CAUSED BY OUTDOOR EXPOSURE TO THE ELEMENTS.
REPLACE ANY DAMAGED CAFÉ LIGHT STRINGS.
DO NOT INSTALL IN LOCATIONS WHERE CAFÉ LIGHTS CAN BE STEPPED ON.
ENSURE CAFÉ LIGHTS ARE UNPLUGGED FROM POWER DURING INSTALLATION.
CAFÉ LIGHTS SHOULD BE INSTALLED OUT OF THE REACH OF CHILDREN OR NOT ALLOW CHILDREN TO PLAY WITH THEM.

RISK OF FIRE

CAFE LIGHTS ARE DESIGNED TO BE MOUNTED WITH THEIR INDIVIDUAL KEYHOLE MOUNTING FEATURE, DO NOT MOUNT CAFÉ LIGHTS BY USING THE MAIN ELECTRICAL CORD OR THE INDIVIDUAL DROP CORDS.
DO NOT MOUNT CAFÉ LIGHTS IN ANY POSITION WHERE THE BULB IS FACING UP.
DO NOT ALLOW THE LED LAMP ASSEMBLIES TO BE IN CONTACT WITH COMBUSTIBLE MATERIALS. LED LAMP ASSEMBLIES SHOULD HANG FREELY AND NOT BE SUSCEPTIBLE TO REPETITIVE DAMAGE CAUSED BY ENVIRONMENTAL CONDITIONS SUCH AS WIND, RAIN, AND ICE.

MADE IN CHINA / HECHO EN CHINA
DISTRIBUTED BY JASCO PRODUCTS COMPANY LLC,
10 E. MEMORIAL RD., OKLAHOMA CITY, OK 73114.
Patents pending
Questions? Contact our U.S.-based Consumer Care at
1-855-698-8324 between 7 AM—8 PM, M-F, Central Time.
48372, 48374 Manual V2
2/19/20