drive RTL12203KDR Shower Bench Instruction Manual
- June 6, 2024
- Drive
Table of Contents
assembly instructions
Weight Capacity: 300 lbs (136 Kg)
- Remove contents from the carton.
- Turn the seat up-side-down. Place the leg section marked with a “B” into the groove on the bottom of the seat. Place leg section “A” on top of section “B” and secure both in place by inserting a thumbscrew through the middle hole as shown below.
Finish securing the legs in place by inserting the remaining 4 thumb screws into the 4 outer holes and tightening as shown below.
Insert legs into leg frames by depressing push pins, sliding legs over the receptacle, and setting to the desired height. Make sure all the legs are set to the same height.
1. Before use, adjust the height of each leg to your specific needs, making
sure all legs are at the same height. When the desired height is reached, lock
legs into place by aligning buttons into proper holes, per
illustration.
2. To be sure legs are locked into place by pushing down on or by pulling legs.
- Inspect all parts for shipping damage before assembly. If there is shipping damage – DO NOT USE. Contact dealer/carrier for further instructions.
- Make certain that the height adjusting snap buttons fully protrude through the same respective hole of each leg extension. This will ensure that the leg extensions are securely locked in position and an even height is achieved.
- Ensure thumbscrews are tightened.
- Check the rubber tips on the leg extensions for rips, wear, or if they are missing. Immediately replace any or all if any of these imperfections exist.
- All four leg extensions with rubber tips MUST touch the floor simultaneously at all times.
- When used in a tub, make certain the rubber tips are not touching the sides of the tub wall
- DO NOT stand on a chair.
NOTE: To maintain the beauty of the original finish, clean with mild soap and rinse with warm water. Wipe bath seat dry after each use.
maintenance
Drive recommends periodic visual inspection of this product by the user, to
ensure that all parts and hardware are secure, that components are in good
working order and not worn, torn, frayed, loose, or rusted, and that there are
no obstructions or impediments to normal, safe operation. If any part or
mechanism appears to be unsafe or compromised, do not use the product. If you
experience problems, please contact the provider that sold you the product or
visit www.drivemedical.com/help for more info.
lifetime limited warranty
Your Drive brand product is warranted to be free of defects in materials and
workmanship for the lifetime of the original consumer purchaser. This device
was built to exact standards and care fully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our confidence in the materials
and workmanship of our products and our assurance to the consumer of years of
dependable service.
This warranty does not cover device failure due to own er misuse or
negligence, or normal wear and tear. The warranty does not extend to
nondurable components, such as rubber accessories, casters, and grips, which
are subject to normal wear and need periodic replacement. If you have a
question about your Drive device or this warranty, please contact an
authorized Drive dealer.
© 2020 Medical Depot, Inc.
All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050
The USA Made in China
shower bench
EU Authorized Representative
Y Sung Handelscertretung
Duesselthaler Str. 24 40211
Duesseldorf, Germany
www.drivemedical.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>