Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual

June 6, 2024
Baseus

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User
Manual

1. Product Introduction

Thanks for your dosing our wireless charger, this wireless charger support charging for mobile phone and iWatch at the moment; Before you use this product, Please read this manual carefully and save it.

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual -
Product Introduction

2.Specification

Brand: Baseus
Name: Wireless Charger
Modet:BS-W508X
Material :Aluminum alloy+-Glass -t PC
literate: Type-Cnut
input: 9v=2A ,12V- 2A
output: 7.5W+7.5W/10W+SN Max
Transmission frequency : 115-205kHz
Accessories:1YPE-C cable 1ml
Compatibility: Supports Qi-com pliant wireless charging devices
Size: 160mm~80mm
7.3mm
Weight : About 130.3g

3.Package List

Wireless Charger l
User Manual
l
Warranty card l
Charging Cable
1

4.Instruction

  1.  After the product is inserted into the adapter, the indicator lights go off after is, and the product goes into standby mode.

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual -
Instruction

  1. Charging mode: green light breath.

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual -
Charging Mode

  1. Point your phone at the center” of the wireless charger, and the wireless charger starts working. If it cannot work property, please adjust the position of the mobile phone until the mobile phone displays normal charging; (please refer to the following figure for placement)

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual -
Point your phone at the center of the wireless charger

  1. FOD: Light flicker.

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual - Food
Light flicker

5.Caution

  1. To achieve best perform a net of this wireless charger, or ‘:N “2A. adapter+!! suggested to adapted.
  2. ln the paces of daring, do not put any metal materials like key, ring, metallic phone case etc. on the back of phone device or wireless charger directly.
  3. It may occur occasional intermittent charging or serious heating due to the unjustified position of phone never coil and wireless charging_. please try to cold your phone, then move your phone to earl)’ out the alignment.
  4. This product has over current/voltage protection, it will be shut off or reduce output if used in incorrect way, Please check whether your device is abnormal or not
  5. Please use this product temperature of 0-25″c, DO NOT Expose the product to walker fire, or overheated and lower temperature environment, the product wish be unavailable, Do not let children to touch accessories.
  6. Please use dry, clean soft cloth to clear product surface, 00 NOT use chemistry material and soap to clean.
  7. Manufacturer will not be responsible for those defects which caused by users, Please kindly understand.
  8. iPhone will not be quick charged in below three status:
    a) The electricity power >60%
    b) iOS version: below 11.1.2
    c) iPhone’ s temperature: >35-40ºc

This device complies With part 15ofthe FCC Rules. Operation is subject to the following two conditions: (1) this device may not reuse harmful interference, and (2) this device must accept any interference rec. dived, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not Installed and used in accordance with the instructions, may cause handful interference to radio communications. However, t here is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is Enco raged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment in to an outlet on a different form that to which the reveries connected.
— Consult the dealer-or an e:w.perienced radio/TV technician for help

FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment During the operation of deice a distance of 15 cm surrounding the device and 20 cm ab above the top surface of the device must be respected.

It is hereby declared that BS-508)(. a product model of Shenzhen Times Innovation Technology Co., ltd., complies with the provisions of Directive 2014/35/EU, and Directive 2011/65/ EC. The full text of the EC Declaration of Conformity can be found on the following website: www.baseus.com

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual -
Disposal

Warning: Do not disassemble, hit or put the product Into the fire.

FCC 1D:2AY37-W508X

Baseus BS-W508 Simple 2-In-1 Wireless Charger Pro Edition User Manual -
Certified icon

Manufacturer: Shenzhen Times Innovation Technology Co., Ltd.
Add: 5th Floor, Building B, Baseus Intelligence Park,
No.2008, Xuegang Rd, Gangtou Community,
Bantian Street, Longgang Districts, Shenzhen
Executive Standard: Q/SSCZ 021-2020
Hotline: +B6-4000-712-7ll Website:. www.baseus.com

PB2368-POA1
Designed by Baseus
Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals