MERKURY MI-S074B Chelsea Wireless Soundbar and Speaker User Manual
- June 6, 2024
- Merkury
Table of Contents
WIRELESS SOUNDBAR & SPEAKER
User Manual for MI-S074B
IN THE BOX: Wireless Soundbar & Speaker, Micro USB Cable, User Manual
IMPORTANT: PLEASE READ BEFORE USING THIS PRODUCT
Powering The Soundbar
- Be sure the soundbar is fully charged using the included charging cable. The indicator light will glow red when charging and will turn off when charging is complete.
- The power switch is located on the back of the soundbar.
- The speaker will emit a low chime when the battery is running low.
Control
Top of Soundbar
1. Mode Select (Bluetooth/FM Radio)
2. Volume Up (Press and Hold for Next Track or Station)
3. Play/Pause or Radio Scan
4. Volume Down (Press and Hold for Next Track or Station)
5. LED Indicator
Ports
Back of Soundbar
1. Power On/Off
2. DC5V Charging Input
3. SD Card Input
4. USB Drive Input
5. AUX Input
Connecting to the Soundbar
USB & SD Card| The Chelsea soundbar will automatically switch to this
mode when a USB drive or SD card is detected. The Chelsea Soundbar recognizes
and plays MP3 audio files automatically. Play, pause, skip and repeat tracks
with the onboard controls.
---|---
Aux Input| Simply connect a device to the soundbar via the aux input and
play your music instantly, adjusting the volume on both the device and the
speaker.
Bluetooth| With the soundbar Bluetooth mode, go to your device’s
Bluetooth settings and search for new devices. In a moment, “Merkury S074B”
should appear. Tap it and a sound should emit from the soundbar to indicate
the device is connected!
NOTE: Soundbar will always auto-pair with your device as long as it is in
range and your device’s Bluetooth is enabled.
FM Mode| Always press and hold the scan button when using the radio for
the first time. This will scan for nearby stations.
Specs
Specifications:
Output Power: Dual 3W
Frequency Response: 20Hz to 20KHz
Dimensions (WxHxD): 420mm x 84mm x 67mm| Power Information:
Input: DC 5V Battery Capacity: 1200mAH
Music playing time: Up to 7 Hours
Charging time: 3-4 Hours
Talk Time: Up to 5 Hours*
---|---
Additional Connection Sources:
Audio: 3.5mm AUX cable
Power Source: Built-in rechargeable battery or via USB cable| Bluetooth®
Information:
Bluetooth® Specification: V5.0
Operating Distance: Up to 10m
System Requirements: Bluetooth® enabled device
Troubleshooting
No power| Recharge the soundbar using the included micro USB cable. Try
using a different cable.
---|---
Music is not playing over Bluetooth| Make sure your Bluetooth® device
has an A2DP profile. Check if both devices are paired and connected over
Bluetooth®. Restart the speaker to reconnect your Bluetooth® device.
Bluetooth device will not reconnect with the speaker| Navigate to your
Bluetooth settings menu on your Bluetooth device, tap “Merkury S074B” and
select “Forget.” Now follow the steps to pair your device again.
WARNING: Drilling, sawing, sanding, or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood. K
FCC Notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the two following conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm the radiator
your body. FCC ID: 2AS50-S074B
Technical Support:
Please do not attempt to fix the product by yourself. If you are experiencing
any problems with the product, please do not return it to the store you bought
it from. You can contact our technical support representatives and they will
assist you with any questions you might have.
For assistance operating your product, please consult the User Manual first,
then feel free to contact Merkury Innovations technical support:
Merkury Innovations 45 Broadway, 3rd Floor New York, New York 10006
www.merkuryinnovations.com
E-mail:
support@merkuryinnovations.com
© 2021 Merkury Innovations, LLC. • 45 Broadway 3rd FL. New York, NY 10006
To explore our full selection of products, visit us at:
www.merkuryinnovations.com
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc. The illustrated product and specifications may differ slightly from
those supplied. All other trademarks and trade names are those of their
respective owners.
Made in China
MERKURY INNOVATIONS CONFIDENTIAL
FILE INFORMATION
DATE: 07/19/21
FACTORY: China Etech Groups Ltd.
MODEL NUMBER: MI-S074B-250 (MANUAL)
PRINTER SPECIFICATIONS
FILENAME: MI-S074B-250_Manual_071921_0Lai
SCALE: 100%
SIZE: Trim: W 221mm x H 151mm
PAPER STOCK: 80g Art Paper
FINISH: Matt Lamination
INKS: 1/1 Grayscale
PRESS WORK / NOTES: Trim to size, score, fold, & glue in specified areas.
————————————–Trim
————————————–Score
DO NOT print Comments or Dielines.
The physical sample according to specs must be approved by MERKURY before
proceeding to production.
CONTACT
MERKURY CHINA: Perry
perry@merkuryinnovations.com.cn
COMMENTS (Internal reference only) File created by Eileen
– Please include this manual in all packaging for MI-S074B-250
– Grayscale
– Double-sided printing
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>