MERKURY INNOVATIONS MI-LST12-999 RGB LED Sound Sync Adhesive Strip Lights Installation Guide
- June 5, 2024
- Merkury Innovations
Table of Contents
Installation Guide
Installation
- Be sure to clean the surface you intend to install the strip lights on.
- Peel off the adhesive backing, making sure to not remove the actual adhesive.
- Press and firmly hold the light strip in place for 30 seconds.
- Connect strip lights to IR controller and connect receiver to a power source.
- Remove the tab from the battery compartment of the remote control.
Notes: Not all surfaces have the same textures, and some surfaces may require additional support to hold up the strip lights.
Tips for strip light setup
Tips for
Using your LED Strip Lights
|
---|---
Be sure arrows are matching when connecting strip lights to the connector.|
Remove the tab from the battery compartment of the remote.
|
Be sure surface is wiped and dry before installing.| Remove adhesive backing
without removing actual adhesive.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>