element ECT409W Wireless Washable Mouse User Manual
- June 6, 2024
- Element
Table of Contents
User Manual 
Wireless Washable Mouse
Please read this user manual carefully before you start using this product.
Interface introduction
Specifications
Working Methods:
Dimensions:
Net weight:
DPI Maximum:
Connection:
Working distance:
Input voltage:
Power:
Splash, water, and dust resistant: Key Life:
Operating temperature:
Storage temperature:| Working Methods:
Dimensions:
Net weight:
DPI Maximum:
Connection:
Working distance:
Input voltage:
Power:
Splash, water, and dust resistant: Key Life:
Operating temperature:
Storage temperature:
---|---
Antimicrobial
Mouse with antimicrobial protection is formulated to suppress the growth of odor and stain-causing microorganisms and is not intended for use as a replacement to proper hygiene or for prevention of infectious illness.
General Cleaning Instructions
Spray-Wipe-Spray Method
-
Check whether the battery sealing screw cap is tightened to prevent liquid immersion and damage to the product during cleaning.
-
To avoid accidental keystrokes, entering or deleting important data, unplug the USB adapter from the device, before cleaning.
-
Clean the surface of the item by wiping, gently brushing, dipping it or by following the “spray-wipe-spray” protocol outlined as follows. Spray the product with disinfecting
spray, wipe away dirt and organic solids with a cloth then spray the product completely again with disinfecting spray, allowing the disinfectant to remain on the product for
at least five seconds. -
Either wipe with a dry cloth or shake gently and allow to air dry.
Sanitizing Dip Method
1. Check whether the battery sealing screw cap is tightened to prevent liquid
immersion and damage to the product during cleaning.
2. To avoid accidental keystrokes, entering or deleting important data,
unplug the USB adapter from the device, before cleaning.
3. Soak and flush the mouse with approved cleaning agents and disinfectants.
Water temperature should be less than 50° C (120° F) and water should not be
deeper than 50 cm.
- Don’t use abrasives.
- Recommended cleaning materials: dishwashing liquid, non-abrasive cleanser, general-purpose cleaner, disinfectant, soap water, rubbing alcohol / surgical spirit.
4. Rinse thoroughly to remove any residual cleaning agent.
5. Drying the mouse.
- Shake the mouse to remove any residual water.
- Dry off with a clean towel.
- Do not use a hot-air drier.
- To extend mouse life: Recommended to air dry overnight (about 8 hours).
- Reconnect the mouse.
Europe – EU Declaration of Conformity
The product is in conformity with all the essential requirements and other
provisions of the European Council Directive: Directive 2014/53/EU on Radio
Equipment and
RoHS Directive 2011/65/EU.
Disposal of waste equipment by users in private households in the European
Union
This symbol on the product or on its packaging indicates that this product
must not be disposed of with your other household waste. Instead, it is your
responsibility to dispose of your waste equipment by handing it over to a
designated collection point for the
recycling of waste electrical and electronic equipment. The separate
collection and recycling of your waste equipment at the time of disposal will
help to conserve natural
resources and ensure that it is recycled in a manner that protects human
health and the environment. For more information about where you can drop off
your waste equipment for recycling, please contact your local city office,
your household waste disposal service, or the shop where you purchased the
product.
FCC ID
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
FCC ID: 2A3ZM-ECT409W
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>