Leather Element F0032 Fingerprint Drawer Lock User Manual

Leather Element F0032 Fingerprint Drawer Lock

Thank you for purchasing our products
Please read carefully the manual before installation and use

Product parameters

• Name: Fingerprint Drawer Lock
• Operating voltage: 3.3V – 4.2V,
• standby current: 30uA
• Operating temperature: -12 °C – +68 °C
• Number of users: 3
• administrator users; 20 normal users

Warmly reminding
Charging: during normal use, please charge the battery timely when the red light flashes. It can be charged by connecting to a normal Android interface charger. When charging normally, the red light keeps always on. When the battery is fully charged, the red light will turn off automatically. The charging time lasts for 1 5-20 minutes.

Installation instructions

Fingerprint unlock

1. In the initial state, any fingerprint will unlock the system.
2. In the user-registered status, only the registered fingerprint can unlock the system.
3. When the fingerprint is correct, the green light turns on.
4. When the fingerprint is wrong, the red light turns on.

Fingerprint entry method:

1. The first three registered fingerprints are regarded as administrator users, and subsequent fingerprints can only be registered with the verification of the first three fingerprints (administrator users).
   Steps of initial registration (illustration)
   (press and hold 5 seconds — press 5 times –press and hold 5 seconds – press 1 0 times –success)

2. Steps of initial fingerprint registration: Step 1, input the fingerprint of the administrator users (host): press and hold the fingerprint device for 5 seconds, the green light will flash, and then release the finger. Step 2: put
   the finger to be registered on the fingerprint device, remove the finger until the blue light turns on, repeat this for 5 times, and the blue light will flash; step 3, press the fingerprint device with the same finger for 5 seconds, the green light will flash, and repeats this for 1 0 times (each turning on of blue light indicates a successful press). the green light’s keeping lighting up for 3 seconds means that the registration is successful.
   Registered normal users (Illustration)
   (Press and hold for 5 seconds — Verify administrator users — Press 1 0 times — Success)

3. Registration of normal user: press the fingerprint device with the registered finger for 5 seconds, the blue light will flash, and then release the finger. Verify the administrator fingerprint. If the verification is passed, the green light will flash. Place the fingerprint to be registered on the fingerprint device and press it repeatedly for 1 0 times (each turning on of the blue light indicates one successful press). If the green light keeps lighting up for 3 seconds, the input is successful. The subsequent fingerprint registration is completed following the above steps.
   Restore factory settings

4. Restore factory settings: press the fingerprint device with any finger and hold for more than 1 0 seconds, then the red light will flash and release the finger. Press the fingerprint of administrator users (the first or second fingerprint registered ) to have the verification passed, and then the green light will keep lighting on, which indicates that the factory settings have been restored.
   Tips :

5. The system will enter sleep automatically if no operation occurs within 1 0 seconds in the process of fingerprint input or verification.

6. Please replace another finger if the red light flashes twice when repeatedly inputs the fingerprint.

7. Lights description:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>