SECURITY BRANDS 14-RTE300 RTE 300-MHz Request-to-Exit Station User Guide
- June 6, 2024
- SECURITY BRANDS
Table of Contents
QUICK START GUIDE
RTE 300
Model 14-RTE300
- **Carefully unpack box.
**
- **Make sure you have everything shown here. (Screwdriver not shown)
What’s what?
Important components labeled
**
- **Unlock and remove the faceplate of RTE unit; then using carriage bolts and hex nuts, attach to the pedestal as shown.
WARNING!
AUTOMATIC GATES CAN CAUSE SERIOUS INJURY OR DEATH! ALWAYS CHECK that the
GATE PATH IS CLEAR BEFORE OPERATING! REVERSING or other SAFETY DEVICES SHOULD
ALWAYS BE USED!
**
- **Locate receiver (not included) and open for access to DIP switches.
NOTE: For a gate installation, the receiver is typically installed inside
the gate operator housing.
**
-
Carry RTE unit to a receiver; then set DIP switches on RTE unit to match DIP switches on the receiver. Double-check for a match.
NOTE: Use the blanks above to note positions. Use an “X” for ON and leave blank for OFF. DIP switches may be labeled differently. The word, OPEN, means the same thing as OFF.
-
Make sure the gate/door path is clear; then press the exit button on the RTE unit and the confirm gate/door opens. (If nothing happens, go back to Step 5)
**A**The RTE unit can be disabled or enabled at any time using the key
switch located below the exit button.
IMPORTANT!
The RTE 300 is compatible ONLY with 300-MHz RECEIVERS that use 10
DIP SWITCHES, including those with the Digi-Code or Multi-Code®
brands.
This unit WILL NOT WORK with any other receivers!
If you are not sure what kind of receiver you have, check with your
distributor.
INSTALLATION COMPLETE!
Your system is ready to use.
NEED HELP
Call 972-474-6390
Email
techsupport@securitybrandsinc.com
We are available Mon–Fri / 8 am–5 pm Central
© 2021 Security Brands, Inc. All rights reserved.
QSG-14RTE300-EN Rev. B (10/2021)
Documents / Resources
|
SECURITY BRANDS 14-RTE300 RTE 300-MHz Request-to-Exit
Station
[pdf] User Guide
14-RTE300, RTE 300-MHz Request-to-Exit Station, 14-RTE300 RTE 300-MHz Request-
to-Exit Station
---|---