SuperFish Koi Pro Combi Drum 30000 Module User Manual

SuperFish Koi Pro Combi Drum 30000 Module User Manual

General instructions

Read this manual carefully before using this device. Keep this manual for future reference.

Meaning of symbols
The following warning symbols and/or signal words are used in this manual:

DANGER!
This means an imminent danger due to electric current. Failure to follow the safety instructions can result in serious or fatal injury and/or serious damage to the product or environment.
WARNING!
This means a dangerous situation due to UV-C radiation. Failure to follow the safety instructions can result in serious eye damage and damage to the skin.
WARNING!
This means a dangerous situation. Failure to follow the safety instructions can result in moderate or minor personal injury and/or damage to the product or environment.

NOTICE!
This means caution, useful information or advice.

Fig. … This refers to the relevant drawing … on pages 2 and 3 of this manual.

Meaning of the symbols on the device itself:

Risk of electric shock. Connect only to an earthed electrical outlet, protected by a residual-current device (RCD)/
ground-fault-circuit-interrupter (GFCI).
This UVC device produces harmful radiation, direct contact can be dangerous for the eyes and skin. Always turn off the UV lamp before opening.
Do not directly stare at the light source.
This device complies with all applicable EU standards.
This device may not be disposed of with normal household waste but must be collected separately for recycling.

Use

Immersion UVC built into the SuperFish Koi Pro Combi Drum 30000 filter.

Safety

Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may endanger persons or the environment.

• WARNING! This UVC device emits UV-C radiation, which can cause serious eye damage and/or damage to the skin. The UV lamp must therefore always be installed completely shielded from the eyes.
• Never look at a burning UV lamp. Do not switch on the lamp until it is fully shielded installed and fully submerged.
• This device must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
• Ensure the voltage shown on the label matches the mains supply voltage.
• This device must be connected to a socket which is earthed.
• Protect the socket and plug against moisture. Use a drip loop to ensure that water cannot reach the socket and control box via the cord (see Fig. A).
• Don’t use the product if the device, quartz glass, cord or plug is damaged. Replace the quartz glass or return the device to your dealer for repair or recycling.
• Be careful with the combination of water and electricity. Do not operate with wet hands. Dry hands before carrying out maintenance.
• Always switch off all devices in the pond before maintenance. Disconnect the plug(s) from the socket.
• NOTICE! The UV lamp becomes warm. The UV lamp becomes warm. Allow the lamp to cool for at least 10 minutes before carrying out maintenance.
• Make sure that the UV lamp is always fully submerged below the water level. If the lamp is not fully submerged, it will overheat and breakdown.
• In the event of frost or the risk of frost, appropriate precautions must be taken to prevent it from freezing.
• This device can be used by children aged from 8 years and above, persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or instructions concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and maintenance of the device shall not be done by children without supervision.
• Modifications to the device may affect the safety. The warranty will also expire.
• Aquadistri is not liable for any problems, damage or accidents due to incorrect use of this device.

Product Overview

Figure A,B,C

Function

The built-in submersible UVC ensures crystal-clear water. The UV lamp produces ultraviolet light with a wavelength of exactly 254 nm, thus meaning best effectiveness at this wavelength. The UV-C radiation keeps algae growth under control. The built-in submersible UVC ensures crystal-clear water. Due to its position under the drum, the UV radiation keeps the screen panel free of biofilm and algae deposits. This ensures a longer interval between flushings and significantly lower water consumption.

Installation

Fig. C Remove the quartz glass (c) from the packaging and slide the O-ring (g) over the plastic part of the quartz glass.

• Slide the quartz glass into the adapter (b). Make sure that the O-ring (g) remains in place between the edge of the
  adapter and quartz glass.

• Place the O-ring (h) correctly in the top of the quartz glass.

• Unpack the UV lamp (d) and carefully slide the lamp halfway into the quartz glass (c).

• Insert the lamp into the lamp holder (e) and slide it further into the quartz glass. Make sure that the pawl in the plastic part of the quartz glass falls into the recess of the lamp holder, which activates a microswitch. The microswitch is an extra security, it ensures that the UV lamp is always switched off automatically when disassembling (in case you forgot to switch off the UV lamp).

• Tighten the lock nut (f) hand-tight at the adapter (b), so that it is firmly in place.

• Check the whole assembly for possible leaks.

• Insert the plug into the control box (see manual of the Combi Drum filter) at the specified position.

• Make sure that the UV lamp is completely submerged and the filter cover is closed before before switching it on.

Maintenance

• Remove the plug from the socket before carrying out maintenance!

• The UVC device should be cleaned twice a year. As soon as algae growth increases, check the UVC device and UVlamp and clean the whole or exchange the UV lamp (Art. N6050125) as needed.

• The lamp is hot, wait 10 minutes after switch off before opening the UVC device.

• Ensure that the water is drained out of the filter first, before removing the UVC device.

• Undo the lock nut (f) and remove first the lamp holder (e) and then carefully the UV lamp (d) from the quartz glass (c).
  Then remove the quartz glass from the adapter. If necessary, you can also replace the lamp.

• The High Output UV lamp has an effective life span of approximately 16,000 hours (±2 years). The lamp will still burn beyond this period, but the UV radiation is no longer effective.

• Clean the quartz glass outer face with a soft cloth and SuperFish Pump & UVC Clean carefully. After cleaning, thoroughly rinse the quartz glass with clean tap water and check for damage. Replace the quartz glass (Art. N6050135) if it shows any damage (to prevent glass breakage).

• Reinstall everything, making sure the O-rings are correctly positioned.

• Tighten the lock nut (f) hand-tight at the adapter.

• Check the whole assembly for possible leaks.

Recycling

This symbol indicates that this product (if it is discarded) may not be disposed of with normal household waste.
Instead it must be handed in at an official collection centre (e.g. HWRC). Or can be returned to the dealer when purchasing a similar new product. Follow the applicable rules in your country for the separate collection of electrical and electronic products.
Separate collection and recycling are better for the environment, public health and reduces waste.

Warranty

2 years manufacturer’s warranty on materials and construction defects. Devices must be returned complete with all components, accompanied with an official proof of purchase confirming a purchase date for any warranty claims. Incomplete devices of which parts are missing, and devices without proof of purchase are not eligible for warranty. After receiving and checking, we will determine whether the device will be repaired or replaced. For a device repaired or replaced under warranty, the remaining time of the original warranty period applies. Carefully read the instructions on installation, use and maintenance. Damage due to incorrect use, damage due to contamination or not cleaning the device, glass breakage and damage to the cord are not covered by the warranty.
Always keep the proof of purchase, without proof of purchase the warranty will be void!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>