COMPUSTAR 2WQ9R-FM 2-Way Remote User Manual
- June 6, 2024
- COMPUSTAR
Table of Contents
- COMPUSTAR 2WQ9R-FM 2-Way Remote User Manual
- COMPUSTAR 2WQ9R-FM 2-Way Remote
- WARNING
- FCC COMPLIANCE
- CAUTION
- IC COMPLIANCE
- Radiation Exposure Statement
- RF Specification
- Introduction
- Warranty Coverage
- Quick Reference
- Remote Maintenance – Battery Replacement
- 2 Way Remote Button Functions
- Function Button Menu
- Remote Option Menu Table
- Auxiliary Extender Button Table
- Description of antenna module installation position
- Remote Coding / Programming Routine
- Programming Remotes:
- Exiting Programming:
- Remote Start Error Diagnostic
- Remote Start Shutdown Error Codes
- Limited Lifetime Warranty
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
COMPUSTAR 2WQ9R-FM 2-Way Remote User Manual
COMPUSTAR 2WQ9R-FM 2-Way Remote
Model Name | FCC ID | IC Number |
---|---|---|
2WQ9R-FM | VA5RCL300-2WFX | 7087A-2WRCL300FX |
ANT-2WFMX | VA5JA1000-2WFX | 7087A-2WA1000FX |
WARNING
It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner.
- When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in “Park” in order to avoid accidents upon remote starting. (Note: Make sure that the automatic vehicle cannot star in “Drive”.)
- It is the user’s responsibility to ensure that the remote starter is disabled or put into valet mode before servicing.
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- T his device may not caus e harmful interference
- T his device must accept any interference received, including interference that may cause undesired operation.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.
IC COMPLIANCE
This device
contains licence exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada s licence exempt RSS(s).
Operation is subject to the following two conditions:
- T his device may not cause interference
- T his device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure Statement
This device complies with FCC radiation exposure limit set forth for an
uncontrolled environment.
For ANT 2W FMX : This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
RF Specification
2WQ9R FM : 433.92 ㎒ / FSK
ANT 2W FMX : 433.92 ㎒ / FSK
Introduction
Thank you for purchasing a Fritsch system for your vehicle. Please take a
minute to review this entire manual. Note that this manual applies to the 2
Way 5 Button Liquid Crystal Display Remote (2WQ9R-FM) whether you purchased
the ALARM IT, START IT, or MAX IT system. There are certain features listed in
this manual that may not be available for your system. There may also be
features listed in this manual that require additional installation or
programming before they are active.
If you have any questions or concerns please contact the original place of
purchase. For further information you may also contact our customer support
center at 888-820-3690.
Warranty Coverage
Caution: The Manufacturer’s warranty will be voided if this product is
installed by anyone other than an Authorized Firstech dealer. For complete
warranty details visit www.compustar.com or the last page of this manual.
Firstech remotes carry a 1 year warranty from original date of purchase.
Warranty registration can be complete d online by visiting www.compustar.com .
Please complete the registration form within 10 days of purchase. We do not
include a mail in warranty registration card
with each unit registration must be done online. To verify that an authorized
dealer installed your system, we highly recommend that you keep a copy of the
original proof of purchase, such as the
dealer invoice in a safe place.
Quick Reference
Remote Maintenance – Battery Replacement
The only regular maintenance this system requires is remote control battery
replacement. No programming is required when replacing the battery.
Turn the remote over and unlock the battery cover by sliding the black button
push. Slide the battery cover off, revealing the AAA battery. IMPORTANT: Be
sure to observe correct polarity when installing the battery.
2 Way Remote Button Functions
Button | Duration | Description |
---|
| Short(0.5 sec)| Locks doors and if equipped, arms the alarm.
Double| Unlocks doors and if equipped, disarms the alarm.
Long(2.5 sec)| Holding this button will start your vehicle. Repeat and this
will
shut your vehicle down.
| ****
Short(0.5 sec)
| Car Check (updates vehicle status on remote pager) / Secure Auxiliary / Temperature Display / Vehicle Voltage Display /
Remote Voltage Display
Double| Accesses Remote Menu (Passive arming, Alert mode, etc)
See Remote Menu Table for details.
| Short(0.5 sec)| Locks doors and if equipped, arms the alarm.
Double
| Used as Auxiliary 1 and Sliding door right, Defrost function according to the setting of AUX 1 Config in the remote menu. Not available when set to OFF in AUX 1 Config of the remote
menu.
Long(2.5 sec)| Panic/vehicle locater (flashes vehicle’s parking lights and
sounds siren and horn).
| Short(0.5 sec)| Unlocks doors and if equipped, disarms the alarm.
Double
| Used as Auxiliary 2 and Sliding door left, Head lights function according to the setting of AUX 2 Config in the remote menu. Not available when set to OFF in AUX 2 Config of the remote
menu.
Long(2.5 sec)| Run time extender. Resets the run time for Turbo Timer or
Remote Start.
| Short(0.5 sec)| LCD View
Long(2.5 sec)| Trunk release. Triggers the trunk release output and opens
the vehicle’s trunk.
| Long(2.5 sec)| Option programming menu 1. For use during
installation.
| Long(2.5 sec)| Option programming
menu 2. For use during installation.
Function Button Menu
Button | Duration | Description |
---|
| Double| Enter remote menu
Long(2.5 sec)| Exit remote menu
| Short(0.5 sec)| Remote menu
selection and operation.
| Short(0.5 sec)| Move to the up of the remote menu
| Short(0.5 sec)| Move to the down of the remote menu
Remote Option Menu Table
Auxiliary Extender Button Table
Description of antenna module installation position
<< Installation of Antenna Module >>
Note: Use the power of car battery(+12volts). The Antenna module have been calibrated for horizontal installation at the left-top corner of the windshield.
Remote Coding / Programming Routine
IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.
Programming Remotes:
STEP 1: Activate Valet/Programming mode by manually turning the ignition key
on and off (between the Acc & On positions) five times within 10 seconds. The
vehicle’s parking lights will flash once with the successful completion of
this step.
STEP 2: Within 2 seconds after cycling the ignition for the 5th time, tap the
Lock button on 2 way remotes or the (lock) button on 1 way remotes for a half
second. The parking lights will flash once to confirm the transmitter has been
coded.
Exiting Programming:
Programming is a timed sequence. The parking lights will flash twice signaling
the end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in step 2,
code additional remotes by pressing button (I) on 2 way remotes or the (lock)
button on 1 way remotes. The parking lights will flash once confirming each
additional remote. All compatible systems can recognize up to 4 remotes.
Remote Start Error Diagnostic
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will flash again corresponding to the error table.
Number of Parking Light
Flashes
|
Remote Start Error
---|---
1| Motor running or must first program tach
2| Key in ignition on position
3| Door open (manual transmission only)
4| Trunk open
5| Foot brake on
6| Hood open
7| Reservation off (manual transmission only)
8| Tach or tachless sensing failure
9| FT-DAS sensor shutdown
10| System is in Valet Mode
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us directly.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking lights will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate the shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.
Number of Parking Light
Flashes
|
Remote Start Shutdown Error
---|---
1| Lost engine sensing signal
2| Lost emergency brake signal
3| Foot brake triggered
4| Hood pin triggered
Limited Lifetime Warranty
Firstech, LLC Warrants to the original purchaser that this product shall be free of defects in material and workmanship under normal use and circumstances for the period of time that the original owner of this product owns the vehicle in which it is installed; except that the remote controller unit for the period of one year from the date of installation to the original owner of this product. When the original purchaser returns the product to the retail store where it was purchased or prepaid postal to Firstech, LLC., 21903 68th Avenue South, Kent, WA 98032, USA within the warranty period, and if the product is defective, Firstech, LLC, will at its option repair or replace such.
TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COMMERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO, THE EXCLUSION OF ANY AND ALL WARRANTY OF MERCHANTAPILITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OR PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD. NEITHER THE MANUFACTURER OF ANY ENTITIES CONNECTED THEREWITH SHALL BE RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE. NOTWITHSTANDING THE ABOVE, MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE.
Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation on how long an implied warranty will last or the exclusion or limitation of incidental or consequential damages. This warranty gives you specific legal rights, and you may also have other rights, which vary State to State.
Firstech, LLC. is not RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE that may or may not resulted from the operation of Compustar, Compustar Pro, Arctic Start, Vizion, or NuStart. NOT WITH STANDING THE ABOVE, MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE.
Your Warranty
The product’s warranty is automatically void if the date code or serial number
is defaced, missing or altered. This warranty will not be valid unless you
have completed the registration card at www.compustar.com within 10 days of
purchase.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>