COMPUSTAR 2WT13R-SF 2 Way 3 Button LCD Remote User Manual

June 5, 2024
COMPUSTAR

COMPUSTAR-LOGO

COMPUSTAR 2WT13R-SF 2 Way 3 Button LCD Remote

COMPUSTAR-2WT13R-
SF-2-Way-3-Button-LCD-Remote-PRODUCT

WARNING

It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner.

  1. When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in “Park” in order to avoid accidents upon remote starting. (Note: Make sure that the automatic vehicle cannot star in “Drive”.)
  2. It is the user’s responsibility to ensure that the remote starter is disabled or put into valet mode before servicing.

FCC COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.

IC COMPLIANCE

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure Statement

This device complies with FCC radiation exposure limit set forth for an uncontrolled environment. For ANT-2WSF: This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

RF Specification

  • 2WT13R-SF : 907 ㎒ ~ 919 ㎒ (7CH) DSSS
  • ANT-2WSF : 907 ㎒ ~ 919 ㎒ (7CH) DSSS / 125 ㎑ LF transmitter

Introduction

Thank you for purchasing a Firstech system for your vehicle. Please take a minute to review this entire manual. Note that this manual applies to 2 Way 3 Button Liquid Crystal Display Remote (2WT13R-SF) whether you purchased the ALARM IT, START IT, or MAX IT system. There are certain features listed in this manual that may not be available for your system. There may also be features listed in this manual that require additional installation or programming before they are active.
If you have any questions or concerns please contact the original place of purchase. For further information you may also contact our customer support center at 888-820-3690.

Warranty Coverage

Caution:
The Manufacturer’s warranty will be voided if this product is installed by anyone other than an Authorized Firstech dealer. For complete warranty details visit www.compustar.com or the last page of this manual. Firstech remotes carry a 1-year warranty from original date of purchase. Compustar Pro 2WT13R-SF remote carries a 3-year warranty. Warranty registration can be completed online by visiting www.compustar.com. Please complete the registration form within 10 days of purchase. We do not include a mail in warranty registration card with each unit – registration must be done online. To verify that an authorized dealer-installed your system, we highly recommend that you keep a copy of the original proof of purchase, such as the dealer invoice in a safe place.

Remote Image

Quick Reference

Remote Maintenance – Battery Charging
The 2WT13R-SF comes with a rechargeable battery. Use the included power adapter and micro USB cable to charge your remote.
First, locate the micro USB port on the top of your remote. Connect your micro USB cable to your computer or USB power adapter. The LCD on the front of the remote will showing that your remote is charging. This should take approximately 2 hours.

2 Way Remote Button FunctionsCOMPUSTAR-2WT13R-SF-2-Way-3-Button-LCD-
Remote-FIG-2

Function Button Menu

COMPUSTAR-2WT13R-SF-2-Way-3-Button-LCD-Remote-FIG-3

Remote Option Menu Table

COMPUSTAR-2WT13R-SF-2-Way-3-Button-LCD-Remote-FIG-4COMPUSTAR-2WT13R-SF-2-Way-3-Button-LCD-Remote-
FIG-5 COMPUSTAR-2WT13R-SF-2-Way-3-Button-
LCD-Remote-FIG-6

Auxiliary Extender Button Table

COMPUSTAR-2WT13R-SF-2-Way-3-Button-LCD-Remote-FIG-7

Description of antenna module installation position

COMPUSTAR-2WT13R-
SF-2-Way-3-Button-LCD-Remote-FIG-8

Note:
Use the power of car battery(+12volts). The Antenna module have been calibrated for horizontal installation at the left-top corner of the windshield.

Remote Coding / Programming Routine

IMPORTANT:
Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.

Programming 2 Way 4 Button Remotes:

  1. STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 10 seconds. The vehicle’s parking lights will flash once with the successful completion of this step.
  2. STEP 2: Within 2 seconds after cycling the ignition for the 5th time, tap the Lock button on 2-way remotes or the (lock) button on 1-way remotes for a half-second. The parking lights will flash once to confirm the transmitter has been coded.

Exiting Programming:
Programming is a timed sequence. The parking lights will flash twice signaling the end of programming mode.

Programming Multiple Remotes:
After the confirmation flash given in step 2, code additional remotes by pressing button (I) on 2-way remotes or the (lock) button on 1-way remotes. The parking lights will flash once confirming each additional remote. All compatible systems can recognize up to 4 remotes.

Remote Start Error Diagnostic

If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will flash again corresponding to the error table.

Number of Parking Light

Flashes

|

Remote Start Error

---|---
1| Motor running or must first program tach
2| Key in ignition on position
3| Door open (manual transmission only)
4| Trunk open
5| Foot brake on
6| Hood open
7| Reservation off (manual transmission only)
8| Tach or tachless sensing failure
9| FT-DAS sensor shutdown
10| System is in Valet Mode

We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us directly.

Remote Start Shutdown Error Codes

If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking lights will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate the shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.

Number of

Parking Light Flashes

|

Remote Start Shutdown Error

---|---
1| Lost engine sensing signal
2| Lost emergency brake signal
3| Foot brake triggered
4| Hood pin triggered

Limited Lifetime Warranty

Firstech, LLC Warrants to the original purchaser that this product shall be free of defects in material and workmanship under normal use and circumstances for the period of time that the original owner of this product owns the vehicle in which it is installed; except that the remote control unit for the period of one year from the date of installation to the original owner of this product. When the original purchaser returns the product to the retail store where it was purchased or prepaid postal to Firstech, LLC., 21903 68th Avenue South, Kent, WA 98032, USA within the warranty period, and if the product is defective, Firstech, LLC, will at its option repair or replace such.
TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COMMERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO, THE EXCLUSION OF ANY AND ALL WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OR PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD. NEITHER THE MANUFACTURER OF ANY ENTITIES CONNECTED THEREWITH SHALL BE RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE. NOTWITHSTANDING THE ABOVE, MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE.
Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation on how long an implied warranty will last or the exclusion or limitation of incidental or consequential damages. This warranty gives you specific legal rights, and you may also have other rights, which vary State to State.
Firstech, LLC. is not RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE that may or may not resulted from the operation of Compustar, Compustar Pro, Arctic Start, Vizion, or NuStart. NOT WITHSTANDING THE ABOVE, MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE.

Your Warranty
The product’s warranty is automatically void if the date code or serial number is defaced, missing or altered. This warranty will not be valid unless you have completed the registration card at www.compustar.com within 10 days of purchase.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals