Ningbo Yusing Lighting S-LR Smart LED Strip Light Instruction Manual
- June 6, 2024
- Ningbo Yusing Lighting
Table of Contents
Ningbo Yusing Lighting S-LR Smart LED Strip Light
Smart RGB 90 LEDs music activated
strip light 10ft with remote
PRODUCT INFORMATION
- Product Name: Smart LED strip light
- Description: Smart RGB 90 LEDs music activated strip light 10 ft with remote
- Driver Input: 100-240V 50/60Hz, 0.2A
- Driver Output: 5V 2A
- Power (LED Driver): 10 W
PACKAGE CONTENTS
INSTALLATION INSTRUCTION
Connect the strip light as shown in the image below. Use remote control and APP to adjust strip light functions.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO USE. PLEASE NOTE THAT THE LED STRIP CAN BE PLACED OUTDOORS BUT POWER PACK MUST BE PLUGGED INDOORS.
NON-REPLACEABLE LED: THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could forth the users authority to operate the equipment.
NOTE
This equipment has been a tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions because harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular situation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Re-orient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.”
Made in China
Printed in China
REMOTE CONTROL FUNCTIONS
- To increase LED brightness
- To decrease LED Brightness
- To turn strip lights OFF
- To turn strip lights ON
- For selecting red Color
- For selecting green color
- For selecting blue color
- For selecting white color
- For selecting pre-set colors
- For FLASH/STROBE/FADE/SMOOTH
BATTERY USE AND DISPOSAL
- For best results use a CR2025 Lithium Battery.
- Install only new batteries in your product.
- Failure to insert batteries in the correct polarity, as indicated in the battery compartment., may shorten the life of the batteries or cause the battery to leak.
- Do not dispose of batteries in fire.
- The CR2025 button battery and the battery tube are considered hazardous waste and should be disposed of properly at your local hazardous waste collection site for proper handling. Be sure the item holds no charge when disposing. Depending on your waste service provider you may be able to recycle your battery. Please check with your waste service provider, as well as your local and state guidelines.
To satisfy FCC RF exposure requirements, a separation distance of 20cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not recommended