Beghelli Rti X5 LG 230 Infinita LED Luminaires Instruction Manual
- October 27, 2023
- Beghelli
Table of Contents
- Beghelli Rti X5 LG 230 Infinita LED Luminaires Instruction Manual
- infinita LED Rti X5 LG 230
- EMERGENCY LUMINAIRE FOR EXIT SIGNS
- OPERATION WITH LOCAL LSSA COMMAND:
- OPERATION WITHOUT LOCAL LSSA COMMAND:
- CALIBRATION OF THE CONNECTION LOAD:
- CODING
- WARNINGS – GUARANTEE
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Beghelli Rti X5 LG 230 Infinita LED Luminaires Instruction Manual
infinita LED Rti X5 LG 230
EMERGENCY LUMINAIRE FOR EXIT SIGNS
AND ESCAPE ROUTES
The luminaire allows a centralised switching as well as dia- gnostic
functions.
The luminaire is equipped with a rotary switch for manual addressing (Fig.
F1). Alternatively the addressing can be done automatically over the central
by read-in of the ID (Fig. F2).
(Fig. G) WIRING DIAGRAM:
-
Consider mains connections (L/+; N/-) and polarity.
-
Connections of the LSSA input: L; N (voltage 198 V to 254 V~) (Fig. G1-G2).
The light flux in normal operation and emergency operation is the same, except of deviating performance of the control gear.
OPERATION WITH LOCAL LSSA COMMAND:
(Fig. G1) For a function as local light switch, put DIP switch “LSSA” to “ON”
and DIP switch “UV” to “LS-T” – the devi- ce will be switched on in normal
operation with present voltage on the local input. (Fig. G2) For a function as
local sub-distribution monito- ring, put DIP switch “LSSA” to “ON” and DIP
switch “UV” to “LS-F” – the device will be switched on in emergency ope-
ration with absent voltage on the local input. (Fig. G2) For a function as
local inverted light switch, put DIP switch “LSSA” to “ON” and DIP switch “UV”
to “LS-F” – the device will be switched on in normal mode with absent vol-
tage on the local input. To activate this function consult the operating
manual of the central.
The device must be programmed to non-maintained mode over the central.
OPERATION WITHOUT LOCAL LSSA COMMAND:
(Fig. G3) Put DIP switch in position “OFF”. The device will be switched by the programming on the central.
CALIBRATION OF THE CONNECTION LOAD:
Factory-set DIP switch.
If the illuminant is defective the current consumption of the control gear
must be smaller than “WFAIL” (Fig. D).
CODING
Addresses: from 1 to 16: (Fig. F1). Addresses: from 17 to 32: (Fig. F1).
WARNINGS – GUARANTEE
- This device shall be used exclusively for the purpose for which it has been Any other use is considered improper and therefore dangerous.
- Contact an authorised technical service centre for repairs possibly required use only original spare parts. The lacked respect of the above conditions may compromise the safety of the
- For details regarding warranty services, contact an autho- rized