ENFORCER SK-919T1-GBQ Single Channel RF Transmitter Instruction Manual
- June 10, 2024
- ENFORCER
Table of Contents
SK-919T1-GBQ Single Channel RF Transmitter
Instruction Manual
SK-919T1-GBQ Single Channel RF Transmitter
- Frequency 315MHz
- Operates up to 500ft (150m)*
- Over 68 billion (6.8×1010) possible codes
- LED transmission indicator
- Includes one 3VDC lithium battery (CR-2032)
- Compact size
- Compatible with all SECO-LARM SK-series receivers of the same frequency
- Also available without logo SK-919T1-GBUQ 315MHz
*Actual range will vary depending on the installation and operating environment
Dimensions
Model| SK-9 1 9T 1 -GBUQ
SK-9 19 T 1 -GBQ| SK-9 1 9T2-GNUQ
SK-9 1 9T2-GNQ| SK-9 1 9T3-GNI_TQ
SK-9 1 9T3-GNQ| SK-9 1 9 T4-GNUQ
SK-9 1 9T4-GNQ
---|---|---|---|---
Power| 3VDC battery (CR-2032, included)
RF Frequency| 315MHz
# of Buttons| 1| 2| 3| 4
Channels| 1| 1| 1| 1
IP Rating| IP 68 Waterproof
Possible codes| Over 68 billion (6.8×1010)
Dimensions| 114″x23/16″x5/16″ (31.5x55x8 mm)
California Proposition 65 Warning: These products may contain chemicals
which are known to the State of California to cause cancer and birth defects
or other reproductive harm. For more information, go to
www.P65Warninqs.ca.qov.
WARRANTY: This SECO-LARM product is warranted against defects in material
and workmanship while used in normal service for one (1) year from the date of
sale to the original customer. SECO-LARM’s obligation is limited to the repair
or replacement of any defective part if the unit is returned, transportation
prepaid, to SECO-LARM. This Warranty is void if damage is caused by or
attributed to acts of God, physical or electrical misuse or abuse, neglect,
repair or alteration, improper or abnormal usage, or faulty installation, or
if for any other reason SECO-LARM determines that such equipment is not
operating properly as a result of causes other than defects in material and
workmanship. The sole obligation of SECO-LARM and the purchaser’s exclusive
remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special. collateral.
incidental. or consequential personal or property damage of any kind to the
purchaser or anyone else.
NOTICE: The SECO-LARM policy is one of continual development and
improvement. For that reason. SECO-LARM reserves the right to change
specifications without notice. SECO-LARM is also not responsible for
misprints. All trademarks are the property of SECO-LARM U.S.A, Inc. or their
respective owners. Copyright © 2023 SECO-LARM U.S.A., Inc. All rights
reserved.
FCC / IC COMPLIANCE STATEMENT
FCC ID: K4E919T4G-1
IC ID: 23770-K919T4GNI341
This device complies with FCC Rules Part 15. Operation is subject to the
following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by doing one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user ‘s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. To maintain compliance
with FCC exposure compliance requirement, please follow operation instruction
as documented in this manual.
This device contains licenceexempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’ s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement.
SECO-LARM® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: 949-261-2999 I
800-662-0800
Email: sales@seco-larm.com
MI_SK-919T1-GxQ_230314 docx
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>