NEXXT NCU-L1300 Wireless Adapter USB User Manual
- June 6, 2024
- NEXXT
Table of Contents
Lynx 1300-AC
Adaptador USB|1300MBPS
Model: NCU-L1300
Quick installation guide
|
---|---
Introduction
Thank you for purchasing the new wireless AC dual-band USB adapter from Nexxt Solutions®. In order to take advantage of this advanced wireless technology, we recommend including our dual-band AC wireless router in your network.
Packege content
If any of the following items are mismatched, missing or damaged, please contact the merchant from whom you purchased the unit for immediate replacement.
- One dualband wireless AC USB adapter
- One quick installation guide
- One software CD [with a digital copy of the quick installation guide, and driver configuration tool)
Installing the USB network adapter
-
Insert the wireless USB adapter into an available USB port on your computer.
-
If the Found New Hardware Wizard system dialogue appear, select Cancel and use the included setup wizard software CD for fast installation.
Initial setup
-
Insert the supplied software CD into the CD drive of your computer. Open the driver folder and double click the installation file. Click Install to run the installation.
-
After the installation is complete, the software will run automatically. Click finish to complete the installation.
-
Double click on the lower right corner of your computer icon all (Network list). Choose your wireless network, then click on Connection. Note: The icon may vary depending on the operating system used.
-
If your network is encrypted, you will be prompted to enter a password. Click OK once you have typed the correct one.
-
From then on, you will be able to start enjoying wireless access to the Internet.
FCC statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC radiation exposure statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 5m m from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and consider removing the no-collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC ID: X4YLNX13AC
NEXXT Solutions” is a registered trademark. All rights reserved. All
other brand names and trademarks are the property of their respective owners.
Made in China.