KOHLER042 Tankless Toilet Remote Actuator User Guide
- June 6, 2024
- Kohler
Table of Contents
Remote Actuator
Tankless Toilet Remote
Users Guide
Indicator Lights
Pairing mode : rapid blue pulsing light
Successful pairing: solid white light
Unsuccessful pairing: solid red light for 3 seconds
Flush: white pulsing light during the flush sequence
Not paired: pulses blue for 3 seconds
Low battery: red light for 4 seconds
End of battery life: pulsing red light
Indicator Lights (fr)
Pairing mode: rapid blue pulsing light
Successful pairing: solid white light
Unsuccessful pairing : solid red light for 3 seconds
Flush: white pulsing light during the flush sequence
Not paired : pulses blue for 3 seconds
Low battery: red light for 4 seconds
End of battery life : pulsing red light
Indicator Lights (sp)
Pairing mode: rapid blue pulsing light
Successful pairing : solid white light
Unsuccessful pairing: solid red light for 3 seconds
Flush: white pulsing light during the flush sequence
Not paired: pulses blue for 3 seconds
Low battery: red light for 4 seconds
End of battery life: pulsing red light
Kohler Co.
1399929-5-A
Battery Replacement
NOTE: If installed, unthread the screws shown in the illustration.
□ Remove the remote actuator from the wall.
□ Install two new AA batteries, oriented properly in the remote.
□ Reinstall the remote actuator onto the wall, ensuring the tabs are aligned.
□ See “Manual Pairing and Flush” for pairing mode instructions.
Battery Replacement (fr)
NOTE: If installed, unthread the screws shown in the illustration.
□ Remove the remote actuator from the wall.
□ Install two new AA batteries, oriented properly in the remote.
□ Reinstall the remote actuator onto the wall, ensuring the tabs are aligned.
□ See “Manual Pairing and Flush” for pairing mode instructions.
Battery Replacement (sp)
NOTE: If installed, unthread the screws shown in the illustration.
□ Remove the remote actuator from the wall.
□ Install two new AA batteries, oriented properly in the remote.
□ Reinstall the remote actuator onto the wall, ensuring the tabs are aligned.
□ See “Manual Pairing and Flush” for pairing mode instructions.
Manual Pairing and Flush
NOTE: The remote and toilet pairing mode will automatically shut off
after 3 minutes.
□ Open the magnetic access cover behind the seat ring.
□ Verify that four AA batteries are installed in the toilet battery tray.
□ Verify that two AA batteries are installed in the remote actuator.
□ Press and hold the wall remote for 3 seconds and release. The unit will
pulse blue.
□ Press the blue button on the toilet to enter pairing mode. A white light
will indicate successful pairing.
□ Press the wall remote to flush the toilet. The remote will pulse white
during the flush sequence.
Manual Pairing and Flush (fr)
NOTE : The remote and toilet pairing mode will automatically shut off
after 3 minutes.
□ Open the magnetic access cover behind the seat ring.
□ Verify that four AA batteries are installed in the toilet battery tray.
□ Verify that two AA batteries are installed in the remote actuator.
□ Press and hold the wall remote for 3 seconds and release. The unit will
pulse blue.
□ Press the blue button on the toilet to enter pairing mode. A white light
will indicate successful pairing.
□ Press the wall remote to flush the toilet. The remote will pulse white
during the flush sequence.
Manual Pairing and Flush (sp)
NOTE: The remote and toilet pairing mode will automatically shut off
after 3 minutes.
□ Open the magnetic access cover behind the seat ring.
□ Verify that four AA batteries are installed in the toilet battery tray.
□ Verify that two AA batteries are installed in the remote actuator.
□ Press and hold the wall remote for 3 seconds and release. The unit will
pulse blue.
□ Press the blue button on the toilet to enter pairing mode. A white light
will indicate successful pairing.
□ Press the wall remote to flush the toilet. The remote will pulse white
during the flush sequence.
FCC Compliance
FCC ID: N82-KOHLER042
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Warning
- This transmitter with its antenna complies with FCC’s RF exposure limits for general population/ uncontrolled exposure.
- This device must not be co-located or operated in conjunction with any other antenna or transmitter.
- This device should be operated with a minimum distance of 7-7/8” (200 mm) between the radiator and your body.
IC: 4554A-KOHLER042
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This transmitter with its antenna complies with Industry Canada RF Exposure
Limits for General Population/Uncontrolled Exposure.
This Class B digital apparatus complies with Canadian ICES-003.
Warranty
This product is covered under the KOHLER® Electronic Faucets, Valves, and
Controls five-year Limited Warranty, found at kohler.com/warranty. For a
hardcopy of warranty terms, contact the Customer Care Center
USA/Canada: 1-800-4KOHLER
kohler.com
1399929-5-A©2021 Kohler Co.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>