vtech 80-542200 Marble Rush Launchpad Set Instruction Manual
- June 6, 2024
- vtech
Table of Contents
vtech 80-542200 Marble Rush Launchpad Set Instruction Manual
INTRODUCTION
Thank you for purchasing the Marble Rush ™ Launchpad Set ™!
Get ready for a rush of non-stop action! Build thrilling courses, send the
marbles into motion and compete with family and friends through exciting
challenges complete with sounds and lights.
WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable
tags, cable ties, cords and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE
Please keep save this manual as it contains important information.
GETTING STARTED
Battery Removal and Installation
- Make sure the unit is turned Off.
- Find the battery cover located on the back of the unit, use a coin or screwdriver to loosen the screw and then open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
- Replace the battery cover and tighten the screw to secure.
WARNING:
CHOKING HAZARD -Toy contains small parts and small balls. Not for children under 3yrs.
IMPORTANT: BATTERY INFORMATION
- Insert batteries with the correct polarity (+ and -).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not short-circuit the supply terminals.
- Remove batteries during long periods of non-use.
- Remove exhausted batteries from the toy.
- Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
- Remove rechargeable batteries from the toy before charging.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not charge non-rechargeable batteries.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
LABEL APPLICATION
Please securely stick the labels to the playset as indicated below:
PRODUCT FEATURES
-
Rocket Sensor
When the Rocket Sensor detects a ball, the unit will play sound effects.
-
Rocket Button
Press the button on the rocket to select the background music.
-
Music/SFX Selector
Slide the selector all the way to the right to turn on both music and SFX. The middle position plays SFX only with no background music. Slide the selector all the way to the left to turn off both SFX and background music.
-
On/Off Switch
Slide the switch to the Off position or the On position to turn the unit Off or On.
-
Automatic Shut-Off
To preserve battery life, the Marble Rush ™ Launchpad Set ™ will automatically power-down after several minutes without input. The unit can be turned on again by sliding the On/Off Switch to the on position or by sliding the Music/SFX Selector to a different position. The unit will also automatically turn off when the batteries are very low.
CARE & MAINTENANCE
- Keep the unit clean by wiping it with a slightly damp cloth.
- Keep the unit out of direct sunlight and away from any direct heat sources.
- Remove the batteries if the unit will not be used for an extended period of time.
- Do not drop the unit on hard surfaces or expose the unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working , please follow these steps:
- Turn the unit Off.
- Interrupt the power supply by removing the batteries.
- Let the unit stand for a few minutes, then replace the batteries.
- Turn the unit On. The unit should now be ready to play again.
- If the unit still does not work, install a brand new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Visit our website for more information about our products, downloads, resources and more.
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty
TM & © 2021 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-003989-000 US
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>