naturaled LED Disk Light 4/6 Inch Round and Square Installation Guide
- June 6, 2024
- naturaled
Table of Contents
Installation Guide
v1.0 1-2
LED Disk Light (4″/ 6″ Round and Square)
WARNING
To reduce the risk of electrical shock, fire, or injury to persons; read and follow all warnings and installation instructions before installing. All installation should be performed by a qualified electrician.
Risk of Electric Shock
Ensure power is off before installation or inspection. All wirings are
performed in accordance with Electrical Code and local electrical code.
Risk of Fire
Fixtures are rated for use in 120V, 60Hz protected circuit, and 90°C rated
supply wire.
FOR YOUR SAFETY
While performing installations described, gloves, safety glasses or goggles
should be worn.
Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
To prevent product malfunction and/or electrical shock, this product must be properly grounded
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not alter, relocate, or remove wiring, lamp holders, power supply, or any other electrical component.
SUITABLE FOR DAMP LOCATIONS.
INSIDE THE BOX
Plusrite USA 2000 S. Grove Ave, Bldg B Ontario CA 91761
T:909-930-6868
T:888-758-7443
F:909-930-9988
www.naturaled.com
INSTALLATION
Disconnect the power before installation. Exploded view of completed assembly with component call out. 1, 2, 3, etc.
PRE-INSTALLATION:
- Turn power OFF from the electrical panel before starting installation.
- Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole CutTable for appropriate size).
INSTALLATION:
-
Remove the knockouts for wiring and open the junction box contains three wires: hot (black) , neutral (white) and bare ground. Connect the two hot wires together (one from the light switch cable and the other from the recessed housing). Repeat the step with two neutral wires. Close the junction box to complete the wiring. ** Simple place electric cables to quick wiring connector. (Fig.1)
-
Connect downlight to junction box. Select your favorite color temperature by using the 5CCT switch on the junction box. (Factory preset temperature is 3000K). Place junction box into the ceiling. (Fig.2)
-
Push the easy mount clips up and insert the downlight into the ceiling, release clips to mount the downlight on the ceiling. (Fig.3)
-
Secure the downlight, the installation is completed. (Fig.4)
Hole Cut Size
4 inch round, 4 inch square| 04-1/4″(108mm)
6 inch round, 6 inch square| 06-1/8″(155mm)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>