naturaled 9571 LED Post Top Light Installation Guide
- June 8, 2024
- naturaled
Table of Contents
LED Post Top Light
Installation Guide
V2.0
9571 LED Post Top Light
WARNING
To reduce the risk of electrical shock, fire, or injury to persons; read and follow all warnings and installation instructions before installing. All installation should be performed by a qualified electrician.
Risk of Electric Shock
Ensure power is off before installation or inspection. All wirings are
performed in accordance with Electrical Code and local electrical code.
Risk of Fire
Fixtures are rated for use in 100-277V, 50-60Hz protected circuit and 90C
rated supply wire.
FOR YOUR SAFETY
While performing installations described, gloves, safety glasses or goggles should be worn.
Install this kit only in the luminaire that have the construction features and
dimensions shown in the photographs and/or drawings. Do not make or alter any
open holes in an enclosure of wiring or electrical components during kit
installation.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet
metal or other sharp objects.
Do not alter, relocate, or remove wiring, lampholders, power supply, or any
other electrical component.
SUITABLE FOR WET LOCATIONS.
The Finished Fixture
Inside the Box
INSTALLATION
Disconnect the power before installation. Exploded view of completed assembly with component call out. 1, 2, 3, etc.
Pole Mounting
-
Pass the wire through the rod
-
Fix the rod on housing with (2) M4*12 Cross round head mechanical tooth screws
-
Fix the other two rods on housing with (2) M8*16 allen screws
-
Pass the wire through the rod and pole adaptor (please choose the correct hole).
-
Fix three rods onto pole adaptor with (2) M816 Hexagon socket set screws and (2) M412 Cross round head mechanical tooth screws.
-
Connect the wires as left wiring diagram
-
Fix the fixture to the post with (6)M8*20 Hexagon so cket set screws
9-1 Built-in Photocell
Choose photocell
function by ON/OFF switch. ON means enable photocell OFF means disable
photocell.
9-2 External Photocell (Sold Separately)
Open the driver
box, install the photocell and NEMA base according to the hole position.
Connect the wires as below wiring diagram, then fix the driver box.
10. Make sure the
installation is complete and turn on the power
Plusrite USA
2000 S. Grove Ave, Bldg B
Ontario CA 91761
www.naturaLED.com
T:909-930-6868
T:888-758-7 443
F:909-930-9988
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>