naturaled FMM CCT5 14-Inch Double Ring Dimmable LED Flush Mount Ceiling Light Fixture Installation Guide

: June 3, 2024
: naturaled

Table of Contents

FMM CCT5 14-Inch Double Ring Dimmable LED Flush Mount Ceiling Light
FOR YOUR SAFETY
INSIDE THE BOX
INSTALLATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FMM CCT5 14-Inch Double Ring Dimmable LED Flush Mount Ceiling Light Fixture
Installation Guide naturaled FMM CCT5 14-Inch Double Ring Dimmable LED
Flush Mount Ceiling Light Fixture

FMM CCT5 14-Inch Double Ring Dimmable LED Flush Mount Ceiling Light

Fixture

LED Flush Mount Modern – FMM (CCT5)
WARNING

To reduce the risk of electrical shock, fire, or injury to persons; read and follow all warnings and installation instructions before installing. All installations should be performed by a qualified electrician.
Risk of Electric Shock
Ensure the power is off before installation or inspection. All wirings are performed in accordance with Electrical Code and local electrical code.
Risk of Fire
Fixtures are rated for use in 120 V, 60Hz protected circuit, and 90°C rated supply wire.

FOR YOUR SAFETY

While performing the installations described, gloves, safety glasses or goggles should be worn.
Install this kit only in the luminaire that has the construction features and dimensions shown in the photographs and/or drawings.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.
Do not alter, relocate, or remove the wiring, lamp holders, power supply, or any other electrical component.
THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR AUTHORITIES HAVING JURISDICTION. SUITABLE FOR DAMP LOCATIONS.

INSIDE THE BOX

naturaled FMM CCT5 14-Inch Double Ring Dimmable LED Flush Mount Ceiling
Light Fixture

12” / 14”/ 16” Flush Mount Modern – FMM
1 – Flush mount Modern housing
1 – Flush mount diffuser (shipped as part of flush mount housing)
3 – Wire nuts (in parts bag)
2 – 1.5” Electrical Box Screws (in parts bag)
1 – Installation Manual

INSTALLATION

Disconnect the power before installation. Exploded view of the completed assembly with component call out. 1, 2, 3, etc.

Before beginning assembly, installation, or operation of the product, make sure all ports are present. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for replacement parts. Loosen screws counterclockwise.
Open the junction box. The junction box contains three wires: hot (black), neutral (white), and bare ground. Connect the two hot wires together with wiring nuts (one from the light switch cable and the other from the recessed housing). Repeat the step with the two neutral wires. Close the junction box to complete the wiring.
Put the fixture plate across the screw of the lock, then rotate the fixture plate clockwise and lock it tightly with the screw lock. Use the switch to choose desired Color Temperature.
Securely mount the fixture plate to the junction box firmly.
Place the Diffuser and tighten the screws clockwise to complete the installation. Restore power to the electrical box. Turn the light switch on to activate the fixture.