naturaled FXFDL Series LED-FXFDL150SW-YK LED Flood Light with Adjustable Yoke Mount Installation Guide
- June 4, 2024
- naturaled
Table of Contents
naturaled FXFDL Series LED-FXFDL150SW-YK LED Flood Light with Adjustable
Yoke Mount
WARNING
To reduce the risk of electrical shock, fire, or injury to persons; read
and follow all warnings and installation instructions before installing. All
installations should be performed by a qualified electrician.
Risk of Electric Shock
Ensure power is off before installation or inspection. All wirings are
performed in accordance with Electrical Code and local electrical code.
Risk of Fire
Fixtures are rated for use in 120-277V, 50-60Hz protected circuits, and 90°C
rated supply wire.
FOR YOUR SAFETY
While performing installations described, gloves, safety glasses or goggles
should be worn.
- Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
- To prevent product malfunction and/or electrical shock, this product must be properly grounded
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not alter, relocate, or remove wiring, lamp holders, power supply, or any other electrical component.
- SUITABLE FOR WET LOCATIONS.
INSTALLATION
Disconnect the power before installation. Exploded view of the completed assembly with component call out. 1, 2, 3, etc.
Installation – Kunckle Mount
- Use the screw key to open the junction box.
- Put the wires of the lamp into the junction box.
- Screw up the knuckle mount into the junction box.
- Use wire nuts to connect the wires of the lamp and junction box.
- Lock the junction box with a screw key.
- Use a hex key to screw off the hex screw in the knuckle mount.
- Adjust the lamp to a suitable angle.
- Use a hex key to screw up the hex screw. Installation completed.
Installation – Yoke Mount
- Mark the position of the fixing holes with a flood light bracket, then drill the fixing holes
- Drive in the bolts to the pre-drilled holes with thread outside, as the below pic indicates.
- Make the bracket face tightly to the wall through the thread.
- Fasten the screw nut clockwise with provided hardware by wrench
- Rotate the light to the proper angle and fasten the screws
- Fasten the screw on both sides with Allen driver
- Connect wires
Utilice una llave de tornillo para abrir la caja de conexiones.
Installation – Slip-fitter
- Loosen the screw used to fix the upper and the lower mount in the rotating shaft by hexagon wrench.
- Rotate the bracket to the proper angle.
- Lock the upper and lower brackets by a hexagon wrench.
- Connect wire.s.
- Fix the bracket to the lamp pole with a hexagonal wrench.
Notice
The maximum diameter of the lamp pole is Ø60mm, lamp adjustable angle is
0-90°
Step of adjusting wattage
- Step 1: Turn the light-emitting side of the lamp downward and twist out the plug with a cross screwdriver;
- Step 2: Take out the plug and put it aside temporarily; set power switch to the corresponding position as required;
- Step 3: Screw the plug back into the power supply cover plate with a screwdriver.
Support replacement instructions
- Loosen the side fastening bolts.
- Remove the yoke bracket.
- Pass the cable through the bracket base and fix the base on the lamp body.
- Thread the cable through the slip fitter bracket and fasten it with bolts.
- Adjust the angle to the required position and lock it.
Notice:
The maximum diameter of the lamp pole is 60, lamp adjustable angle is 0-90°.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>